ZynqMP boot: no messages from SPL other than "Debug uart enabled"
andras.g.major at gmail.com
Tue Apr 28 11:29:48 CEST 2020
>> Thanks for your script, I tried it, it can extract the PMU config object
>> from the FSBL generated by Vitis, but the SD card I prepare this way
>> still doesn't boot.
>> It does one thing differently than before, though: the line
>> ### ERROR ### Please RESET the board ###
> Can you please try xilinx u-boot master branch instead?
Sadly, the result is exactly the same as before. BTW, the Rev1.1
changes are not in master yet, I had to enter them manually.
> Tap delay programming can be one of the reason.
> But the best would be to load it via jtag and look at backtrace where
> the problem is.
How do I debug it via JTAG? Any instructions on that somewhere?
More information about the U-Boot