ZynqMP boot: no messages from SPL other than "Debug uart enabled"

[Michal Simek]

Hi,

On 28. 04. 20 12:53, Major A wrote:
> Hi Michal,
> 
> Xilinx doesn't like me.  Here's the output and where I get stuck:
> 
> xsdb% targets -set -filter {name =~ "PSU"}
> no targets found with "name =~ "PSU"". available targets:
>   1  whole scan chain (DR shift through all zeroes)
> xsdb%
> 
> Any ideas?  Any jumpers I failed to set?  Boot mode is set to JTAG.

check jtag ta - that you see the board. Reset the board, check that jtag
mode pins again.

Thanks,
Michal