[PATCH v1 2/2] board: imx8mq: add boot.cmd for distro boot on iMX8MQ

Alice Guo (OSS) alice.guo at oss.nxp.com
Thu Dec 17 04:36:13 CET 2020


From: Alice Guo <alice.guo at nxp.com>

Distro Boot requires a U-Boot-specific script named boot.scr or
boot.scr.uimg which contains boot commands to boot the system. The
boot.cmd is such a file. Use mkimage to generate boot.scr or
boot.scr.uimg from boot.cmd, and the command is:
mkimage -A arm -O linux -T script -C none -a 0 -e 0 -n "Distro Boot Script" -d boot.cmd boot.scr.uimg

The boot.cmd file is an example script and can be modified based on
needs. bootargs is set in this script and root uses the default value
"/dev/mmcblk1p2 rootwait rw" which can be changed by overriding mmcroot.

On the iMX8MQ platform I used, "mmc0" represents eMMC and "mmc1"
represents SD card.

Signed-off-by: Alice Guo <alice.guo at nxp.com>
---
 board/freescale/imx8mq_evk/boot.cmd | 35 +++++++++++++++++++++++++++++
 1 file changed, 35 insertions(+)
 create mode 100644 board/freescale/imx8mq_evk/boot.cmd

diff --git a/board/freescale/imx8mq_evk/boot.cmd b/board/freescale/imx8mq_evk/boot.cmd
new file mode 100644
index 0000000000..964993e144
--- /dev/null
+++ b/board/freescale/imx8mq_evk/boot.cmd
@@ -0,0 +1,35 @@
+setenv bootargs console=${console} root=${mmcroot};
+
+for boot_target in ${boot_targets};
+do
+        if test "${boot_target}" = "mmc0" ; then
+                if fatload mmc 0:${mmcpart} ${kernel_addr_r} ${image}; then
+                        if fatload mmc 0:${mmcpart} ${fdt_addr} ${fdt_file}; then
+                                echo Load image and .dtb from eMMC(mmc0);
+                                booti ${kernel_addr_r} - ${fdt_addr};
+                                exit;
+                        fi
+                fi
+        fi
+
+        if test "${boot_target}" = "mmc1" ; then
+                if fatload mmc 1:${mmcpart} ${kernel_addr_r} ${image}; then
+                        if fatload mmc 1:${mmcpart} ${fdt_addr} ${fdt_file}; then
+                                echo Load image and .dtb from SD card(mmc1);
+                                booti ${kernel_addr_r} - ${fdt_addr};
+                                exit;
+                        fi
+                fi
+        fi
+
+        if test "${boot_target}" = "dhcp" ; then
+                if dhcp ${kernel_addr_r} ${serverip}:${image}; then
+                        if dhcp ${fdt_addr} ${serverip}:${fdt_file}; then
+                                echo Load image and .dtb from net(dhcp);
+                                booti ${kernel_addr_r} - ${fdt_addr};
+                                exit;
+                        fi
+                fi
+        fi
+
+done
--
2.17.1



More information about the U-Boot mailing list