[PATCH v1 4/5] arm: xea: spl: Add GPIO0_0 setup on spl_board_init

[sbabic at denx.de]

> Explicitly configure GPIO0_0 in SPL, which controlls 3V3 voltage
> on the XEA board (it also supplies TIVAs).
> This code would enable TIVAs power supply early (also when board
> uses the falcon boot).
> Signed-off-by: Lukasz Majewski <lukma at denx.de>
Applied to u-boot-imx, master, thanks !

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================