[U-Boot, 03/13] board: ge: bx50v3, imx53ppd: use DM I2C

[sbabic at denx.de]

> From: Robert Beckett <bob.beckett at collabora.com>
> Remove old (pre-DM) i2c setup code.
> Enable DM i2c.
> Convert common code to use DM rtc.
> Convert common code to read VPD from eeprom partition.
> Convert the generic i2c PMIC init code to use the new da9063 driver.
> mx53ppd only:
> Correct RTC compatible in device tree.
> Enable MXC DM i2c driver.
> Define CONFIG_SYS_MALLOC_F_LEN so that DM is available in pre-reloc.
> Make GPIO banks available during preloc, since initialisation is done
> in board_early_init_f().
> Add gpio_request() calls to satisfy the DM_GPIO compatibility API.
> Remove unused power configuration.
> Signed-off-by: Robert Beckett <bob.beckett at collabora.com>
> Signed-off-by: Ian Ray <ian.ray at ge.com>
Applied to u-boot-imx, master, thanks !

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================