[Uboot-stm32] [PATCH 1/9] ARM: dts: stm32mp1: DT alignment with kernel v5.4

[Patrice CHOTARD]

On 1/28/20 10:10 AM, Patrick Delaunay wrote:
> Device tree and binding alignment with kernel v5.4
>
> Signed-off-by: Patrick Delaunay <patrick.delaunay at st.com>
> ---
>
>  arch/arm/dts/stm32mp157-pinctrl.dtsi             | 8 ++++----
>  arch/arm/dts/stm32mp157c-ev1.dts                 | 5 ++---
>  arch/arm/dts/stm32mp157c.dtsi                    | 4 ++--
>  doc/device-tree-bindings/mtd/stm32-fmc2-nand.txt | 6 ++++--
>  4 files changed, 12 insertions(+), 11 deletions(-)
>
> diff --git a/arch/arm/dts/stm32mp157-pinctrl.dtsi b/arch/arm/dts/stm32mp157-pinctrl.dtsi
> index 0d53396119..07cd0809ff 100644
> --- a/arch/arm/dts/stm32mp157-pinctrl.dtsi
> +++ b/arch/arm/dts/stm32mp157-pinctrl.dtsi
> @@ -622,13 +622,13 @@
>  						 <STM32_PINMUX('F', 6, AF9)>; /* QSPI_BK1_IO3 */
>  					bias-disable;
>  					drive-push-pull;
> -					slew-rate = <3>;
> +					slew-rate = <1>;
>  				};
>  				pins2 {
>  					pinmux = <STM32_PINMUX('B', 6, AF10)>; /* QSPI_BK1_NCS */
>  					bias-pull-up;
>  					drive-push-pull;
> -					slew-rate = <3>;
> +					slew-rate = <1>;
>  				};
>  			};
>  
> @@ -650,13 +650,13 @@
>  						 <STM32_PINMUX('G', 7, AF11)>; /* QSPI_BK2_IO3 */
>  					bias-disable;
>  					drive-push-pull;
> -					slew-rate = <3>;
> +					slew-rate = <1>;
>  				};
>  				pins2 {
>  					pinmux = <STM32_PINMUX('C', 0, AF10)>; /* QSPI_BK2_NCS */
>  					bias-pull-up;
>  					drive-push-pull;
> -					slew-rate = <3>;
> +					slew-rate = <1>;
>  				};
>  			};
>  
> diff --git a/arch/arm/dts/stm32mp157c-ev1.dts b/arch/arm/dts/stm32mp157c-ev1.dts
> index 89d29b50c3..aa5892b156 100644
> --- a/arch/arm/dts/stm32mp157c-ev1.dts
> +++ b/arch/arm/dts/stm32mp157c-ev1.dts
> @@ -189,8 +189,8 @@
>  		clocks = <&clk_ext_camera>;
>  		clock-names = "xclk";
>  		DOVDD-supply = <&v2v8>;
> -		powerdown-gpios = <&stmfx_pinctrl 18 GPIO_ACTIVE_HIGH>;
> -		reset-gpios = <&stmfx_pinctrl 19 GPIO_ACTIVE_LOW>;
> +		powerdown-gpios = <&stmfx_pinctrl 18 (GPIO_ACTIVE_HIGH | GPIO_PUSH_PULL)>;
> +		reset-gpios = <&stmfx_pinctrl 19 (GPIO_ACTIVE_LOW | GPIO_PUSH_PULL)>;
>  		rotation = <180>;
>  		status = "okay";
>  
> @@ -223,7 +223,6 @@
>  
>  			joystick_pins: joystick {
>  				pins = "gpio0", "gpio1", "gpio2", "gpio3", "gpio4";
> -				drive-push-pull;
>  				bias-pull-down;
>  			};
>  
> diff --git a/arch/arm/dts/stm32mp157c.dtsi b/arch/arm/dts/stm32mp157c.dtsi
> index 41aea75213..28a7e4c08a 100644
> --- a/arch/arm/dts/stm32mp157c.dtsi
> +++ b/arch/arm/dts/stm32mp157c.dtsi
> @@ -939,7 +939,7 @@
>  			interrupt-names = "int0", "int1";
>  			clocks = <&rcc CK_HSE>, <&rcc FDCAN_K>;
>  			clock-names = "hclk", "cclk";
> -			bosch,mram-cfg = <0x1400 0 0 32 0 0 2 2>;
> +			bosch,mram-cfg = <0x0 0 0 32 0 0 2 2>;
>  			status = "disabled";
>  		};
>  
> @@ -952,7 +952,7 @@
>  			interrupt-names = "int0", "int1";
>  			clocks = <&rcc CK_HSE>, <&rcc FDCAN_K>;
>  			clock-names = "hclk", "cclk";
> -			bosch,mram-cfg = <0x0 0 0 32 0 0 2 2>;
> +			bosch,mram-cfg = <0x1400 0 0 32 0 0 2 2>;
>  			status = "disabled";
>  		};
>  
> diff --git a/doc/device-tree-bindings/mtd/stm32-fmc2-nand.txt b/doc/device-tree-bindings/mtd/stm32-fmc2-nand.txt
> index 70e76be2a3..ad2bef8265 100644
> --- a/doc/device-tree-bindings/mtd/stm32-fmc2-nand.txt
> +++ b/doc/device-tree-bindings/mtd/stm32-fmc2-nand.txt
> @@ -18,8 +18,10 @@ Optional properties:
>  - dmas: DMA specifiers (see: dma/stm32-mdma.txt)
>  - dma-names: Must be "tx", "rx" and "ecc"
>  
> -Optional children nodes:
> -Children nodes represent the available NAND chips.
> +* NAND device bindings:
> +
> +Required properties:
> +- reg: describes the CS lines assigned to the NAND device.
>  
>  Optional properties:
>  - nand-on-flash-bbt: see nand.txt

Reviewed-by: Patrice Chotard <patrice.chotard at st.com>

Thanks