[PATCH 2/3] ARM: uniphier: remove workaround for the NAND write protect

[Masahiro Yamada]

This workaround was previously needed for LD4, Pro4, sLD8, Pro5
SoCs. The boot ROM does not touch this register for PXs2/LD6b or
later.

Now that the reset signal of the Denali NAND controller is always
asserted in board_init() then deasserted in the driver, the
WRITE_PROTECT register gets back to the default value, which means
the write protect is deasserted.

This workaround can go away entirely.

Signed-off-by: Masahiro Yamada <yamada.masahiro at socionext.com>
---

 arch/arm/mach-uniphier/board_late_init.c | 17 -----------------
 1 file changed, 17 deletions(-)

diff --git a/arch/arm/mach-uniphier/board_late_init.c b/arch/arm/mach-uniphier/board_late_init.c
index 793283058c35..378aad0c9c45 100644
--- a/arch/arm/mach-uniphier/board_late_init.c
+++ b/arch/arm/mach-uniphier/board_late_init.c
@@ -14,25 +14,9 @@
 #include <stdio.h>
 #include <linux/io.h>
 #include <linux/printk.h>
-#include <../drivers/mtd/nand/raw/denali.h>
 
 #include "init.h"
 
-static void nand_denali_wp_disable(void)
-{
-#ifdef CONFIG_NAND_DENALI
-	/*
-	 * Since the boot rom enables the write protection for NAND boot mode,
-	 * it must be disabled somewhere for "nand write", "nand erase", etc.
-	 * The workaround is here to not disturb the Denali NAND controller
-	 * driver just for a really SoC-specific thing.
-	 */
-	void __iomem *denali_reg = (void __iomem *)CONFIG_SYS_NAND_REGS_BASE;
-
-	writel(WRITE_PROTECT__FLAG, denali_reg + WRITE_PROTECT);
-#endif
-}
-
 static void uniphier_set_env_fdt_file(void)
 {
 	DECLARE_GLOBAL_DATA_PTR;
@@ -114,7 +98,6 @@ int board_late_init(void)
 	case BOOT_DEVICE_NAND:
 		printf("NAND Boot");
 		env_set("bootdev", "nand");
-		nand_denali_wp_disable();
 		break;
 	case BOOT_DEVICE_NOR:
 		printf("NOR Boot");
-- 
2.17.1