[PATCH 1/2] ARM: socfpga: Permit overriding the default timer frequency
marex at denx.de
Sat Feb 15 21:43:01 CET 2020
On 2/15/20 8:39 PM, Simon Goldschmidt wrote:
> Am 15.02.2020 um 15:02 schrieb Marek Vasut:
>> The default timer rate may be different than 25 MHz, permit overriding
>> the default rate in board configuration file. Ultimatelly, this should
>> be properly handled by a clock driver, however that is not available
>> on Gen5 yet.
> Sigh, yes, I still haven't found the time to fight those size problems I
> have... :-(
>> Signed-off-by: Marek Vasut <marex at denx.de>
>> Cc: Ley Foon Tan <ley.foon.tan at intel.com>
>> Cc: Simon Goldschmidt <simon.k.r.goldschmidt at gmail.com>
>> include/configs/socfpga_common.h | 2 ++
>> 1 file changed, 2 insertions(+)
>> diff --git a/include/configs/socfpga_common.h b/include/configs/socfpga_common.h
>> index 8d10469e7c..8c5dcfa57c 100644
>> --- a/include/configs/socfpga_common.h
>> +++ b/include/configs/socfpga_common.h
>> @@ -98,8 +98,10 @@
> Just above this line, there's this comment: "This timer uses eosc1,
> whose clock frequency is fixed at any condition".
> While I'm ok with the change below, it does look a bit funny to make
> this overriable if it's "fixed at any condition". Could you elaborate on
> this? Do we need to change the comment?
The comment is probably wrong, since you can connect the SoCFPGA
external oscillator input to any applicable xtal ?
More information about the U-Boot