[PATCH 06/18] video: mxsfb: add support for DM CLK
Giulio Benetti
giulio.benetti at benettiengineering.com
Wed Feb 26 18:15:49 CET 2020
Allow using DM CLK instead of mxs_set_lcdclk() so we can avoid to
implement a special function to set lcd clock on i.MXRT.
Signed-off-by: Giulio Benetti <giulio.benetti at benettiengineering.com>
---
drivers/video/mxsfb.c | 30 +++++++++++++++++++++++++-----
1 file changed, 25 insertions(+), 5 deletions(-)
diff --git a/drivers/video/mxsfb.c b/drivers/video/mxsfb.c
index 585af3d571..f21f8247d9 100644
--- a/drivers/video/mxsfb.c
+++ b/drivers/video/mxsfb.c
@@ -5,6 +5,7 @@
* Copyright (C) 2011-2013 Marek Vasut <marex at denx.de>
*/
#include <common.h>
+#include <clk.h>
#include <dm.h>
#include <env.h>
#include <dm/device_compat.h>
@@ -52,14 +53,32 @@ __weak void mxsfb_system_setup(void)
* le:89,ri:164,up:23,lo:10,hs:10,vs:10,sync:0,vmode:0
*/
-static void mxs_lcd_init(u32 fb_addr, struct ctfb_res_modes *mode, int bpp)
+static void mxs_lcd_init(struct udevice *dev, u32 fb_addr,
+ struct ctfb_res_modes *mode, int bpp)
{
struct mxs_lcdif_regs *regs = (struct mxs_lcdif_regs *)MXS_LCDIF_BASE;
uint32_t word_len = 0, bus_width = 0;
uint8_t valid_data = 0;
+#if CONFIG_IS_ENABLED(CLK)
+ struct clk per_clk;
+ int ret;
+
+ ret = clk_get_by_name(dev, "per", &per_clk);
+ if (ret) {
+ dev_err(dev, "Failed to get mxs clk: %d\n", ret);
+ return;
+ }
+
+ ret = clk_set_rate(&per_clk, PS2KHZ(mode->pixclock) * 1000);
+ if (ret < 0) {
+ dev_err(dev, "Failed to set mxs clk: %d\n", ret);
+ return;
+ }
+#else
/* Kick in the LCDIF clock */
mxs_set_lcdclk(MXS_LCDIF_BASE, PS2KHZ(mode->pixclock));
+#endif
/* Restart the LCDIF block */
mxs_reset_block(®s->hw_lcdif_ctrl_reg);
@@ -135,10 +154,11 @@ static void mxs_lcd_init(u32 fb_addr, struct ctfb_res_modes *mode, int bpp)
writel(LCDIF_CTRL_RUN, ®s->hw_lcdif_ctrl_set);
}
-static int mxs_probe_common(struct ctfb_res_modes *mode, int bpp, u32 fb)
+static int mxs_probe_common(struct udevice *dev, struct ctfb_res_modes *mode,
+ int bpp, u32 fb)
{
/* Start framebuffer */
- mxs_lcd_init(fb, mode, bpp);
+ mxs_lcd_init(dev, fb, mode, bpp);
#ifdef CONFIG_VIDEO_MXS_MODE_SYSTEM
/*
@@ -260,7 +280,7 @@ void *video_hw_init(void)
printf("%s\n", panel.modeIdent);
- ret = mxs_probe_common(&mode, bpp, (u32)fb);
+ ret = mxs_probe_common(NULL, &mode, bpp, (u32)fb);
if (ret)
goto dealloc_fb;
@@ -337,7 +357,7 @@ static int mxs_video_probe(struct udevice *dev)
mode.vsync_len = timings.vsync_len.typ;
mode.pixclock = HZ2PS(timings.pixelclock.typ);
- ret = mxs_probe_common(&mode, bpp, plat->base);
+ ret = mxs_probe_common(dev, &mode, bpp, plat->base);
if (ret)
return ret;
--
2.20.1
More information about the U-Boot
mailing list