[PATCH] net: phy: dp83867: Clean force link good bit
Michal Simek
monstr at monstr.eu
Fri Feb 28 12:17:41 CET 2020
čt 6. 2. 2020 v 16:03 odesílatel Michal Simek <michal.simek at xilinx.com> napsal:
>
> On Xilinx ZynqMP revA board initial value of PHYCR register is 0x5448 which
> means FORCE_LINK_GOOD is already setup. Origin code was doing write but the
> new code is doing read/modify/write and keep this bit untouched. That's why
> ethernet stop to work.
> The patch is cleaning this bit when PHYCR value is composed.
>
> Tested on Xilinx zcu102-revA and zcu104-rev1.0 boards.
>
> Fixes: 37d6265f2bfa ("net: phy: dp83867: refactor rgmii configuration")
> Signed-off-by: Michal Simek <michal.simek at xilinx.com>
> ---
>
> drivers/net/phy/dp83867.c | 4 ++++
> 1 file changed, 4 insertions(+)
>
> diff --git a/drivers/net/phy/dp83867.c b/drivers/net/phy/dp83867.c
> index a43793cd4274..4d796e289c45 100644
> --- a/drivers/net/phy/dp83867.c
> +++ b/drivers/net/phy/dp83867.c
> @@ -64,6 +64,7 @@
> #define DP83867_PHYCR_FIFO_DEPTH_SHIFT 14
> #define DP83867_PHYCR_FIFO_DEPTH_MASK GENMASK(15, 14)
> #define DP83867_PHYCR_RESERVED_MASK BIT(11)
> +#define DP83867_PHYCR_FORCE_LINK_GOOD BIT(10)
> #define DP83867_MDI_CROSSOVER 5
> #define DP83867_MDI_CROSSOVER_MDIX 2
> #define DP83867_PHYCTRL_SGMIIEN 0x0800
> @@ -283,6 +284,9 @@ static int dp83867_config(struct phy_device *phydev)
> val &= ~DP83867_PHYCR_FIFO_DEPTH_MASK;
> val |= (dp83867->fifo_depth << DP83867_PHYCR_FIFO_DEPTH_SHIFT);
>
> + /* Do not force link good */
> + val &= ~DP83867_PHYCR_FORCE_LINK_GOOD;
> +
> /* The code below checks if "port mirroring" N/A MODE4 has been
> * enabled during power on bootstrap.
> *
> --
> 2.25.0
>
Applied.
M
--
Michal Simek, Ing. (M.Eng), OpenPGP -> KeyID: FE3D1F91
w: www.monstr.eu p: +42-0-721842854
Maintainer of Linux kernel - Xilinx Microblaze
Maintainer of Linux kernel - Xilinx Zynq ARM and ZynqMP ARM64 SoCs
U-Boot custodian - Xilinx Microblaze/Zynq/ZynqMP/Versal SoCs
More information about the U-Boot
mailing list