[U-Boot] [PATCH 1/2] imx: add imx8x capricorn giedi board

Fabio Estevam festevam at gmail.com
Tue Jan 7 18:54:55 CET 2020


Hi Anatolij,

On Tue, Oct 22, 2019 at 5:35 AM Anatolij Gustschin <agust at denx.de> wrote:
>
> Add support for i.MX8X based Capricorn Giedi SoM.
>
> Supported interfaces: GPIO, ENET, eMMC, I2C, UART.
>
> Console output:
>
>   U-Boot SPL 2019.10-00178-g6e34009eee (Oct 21 2019 - 18:16:42 +0200)
>   Trying to boot from MMC1
>   Load image from MMC/SD 0x3e000
>
>   U-Boot 2019.10-00178-g6e34009eee (Oct 21 2019 - 18:16:42 +0200) ##v01.07
>
>   CPU:   NXP i.MX8QXP RevB A35 at 1200 MHz at 24C
>
>   Model: Siemens Giedi
>   Board: Capricorn
>   Build: SCFW 65afe5f6, SECO-FW 9d71fd5b, ATF d6451cc
>   Boot:  MMC0
>   DRAM:  1022 MiB
>   MMC:   FSL_SDHC: 0
>   Loading Environment from MMC... OK
>   In:    serial at 5a080000
>   Out:   serial at 5a080000
>   Err:   serial at 5a080000
>   Net:   eth1: ethernet at 5b050000 [PRIME]
>   Autobooting in 1 seconds, press "<Esc><Esc>" to stop
>
> Signed-off-by: Anatolij Gustschin <agust at denx.de>

I am getting a hang on my i.MX8QXP MEK with mainline even if applying
your I2C ipg clock patches:

U-Boot SPL 2020.01-00169-g7f2ff3059d-dirty (Jan 07 2020 - 14:50:41 -0300)
Normal Boot
WDT:   Not found!
Trying to boot from MMC2_2
Load image from MMC/SD 0x46c00


U-Boot 2020.01-00169-g7f2ff3059d-dirty (Jan 07 2020 - 14:50:41 -0300)

CPU:   NXP i.MX8QXP RevB A35 at 1200 MHz at 31C

Model: Freescale i.MX8QXP MEK
Board: iMX8QXP MEK
Boot:  SD1
DRAM:  3 GiB
MMC:   FSL_SDHC: 0, FSL_SDHC: 1
Loading Environment from MMC... *** Warning - bad CRC, using default environment

In:    serial at 5a060000
Out:   serial at 5a060000
Err:   serial at 5a060000
Net:
Error: ethernet at 5b040000 address not set.

(It hangs here)

Where did you get the AT-F, imx-sc-firmware, imx-seco from?

I used these components from 4.19.35 NXP BSP release.

Thanks


More information about the U-Boot mailing list