[PATCH] mpc83xx_clk: always treat MPC83XX_CLK_PCI as invalid

[Mario Six]

On Thu, Dec 19, 2019 at 10:46 AM Rasmus Villemoes
<rasmus.villemoes at prevas.dk> wrote:
>
> The current mpc83xx_clk driver is broken for any board for which
> mpc83xx_has_pci() is true, i.e. anything not MPC8308:
>
> When is_clk_valid() reports that MPC83XX_CLK_PCI is valid,
> init_all_clks() proceeds to call init_single_clk(), but that doesn't
> know about either MPC83XX_CLK_PCI or has any handling of the
> TYPE_SCCR_ONOFF mode correctly returned by retrieve_mode(). Hence
> init_single_clk() ends up returning -EINVAL, and the whole board hangs
> in serial_init().
>
> The quickest fix is to simply pretend that clock is invalid for
> all, since nobody can have been relying on it. Adding proper support
> seems to be a bit more involved than just handling TYPE_SCCR_ONOFF:
>
> - The power-on-reset value of SCCR[PCICM] is 0, so
>   mpc83xx_clk_enable() would probably need to be tought to enable the
>   clock.
>
> - The frequency of PCI_SYNC_OUT is either SYS_CLK_IN or SYS_CLK_IN/2
>   depending on the CFG_CLKIN_DIV configuration input, but that can't
>   be read from software, so to properly fill out
>   ->speed[MPC83XX_CLK_PCI] I think one would need guidance from
>   Kconfig or dtb.
>
> Partially fixes: 07d538d281 clk: Add MPC83xx clock driver
>
> Signed-off-by: Rasmus Villemoes <rasmus.villemoes at prevas.dk>
> ---
>  drivers/clk/mpc83xx_clk.c | 5 ++++-
>  1 file changed, 4 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/clk/mpc83xx_clk.c b/drivers/clk/mpc83xx_clk.c
> index 32d2db9eda..1b2b216596 100644
> --- a/drivers/clk/mpc83xx_clk.c
> +++ b/drivers/clk/mpc83xx_clk.c
> @@ -65,7 +65,10 @@ static inline bool is_clk_valid(struct udevice *clk, int id)
>         case MPC83XX_CLK_DMAC:
>                 return (type == SOC_MPC8308) || (type == SOC_MPC8309);
>         case MPC83XX_CLK_PCI:
> -               return mpc83xx_has_pci(type);
> +               /*
> +                * FIXME: implement proper support for this.
> +                */
> +               return 0 && mpc83xx_has_pci(type);
>         case MPC83XX_CLK_CSB:
>                 return true;
>         case MPC83XX_CLK_I2C2:
> --
> 2.23.0
>
That's OK as a workaround, but should probably be properly fixed (ideally with
the addition of a proper DM PCI driver that works with the clock
driver). But for
now:

Reviewed-by: Mario Six <mario.six at gdsys.cc>

Applied to mpc83xx/next.

Best regards,
Mario