[PATCH v6 0/6] rockchip: Add Binman support

[Jagan Teki]

On Wed, Jan 8, 2020 at 5:04 PM Wadim Egorov <w.egorov at phytec.de> wrote:
>
> Hi,
>
> On 07.01.20 10:59, Kever Yang wrote:
> > Add Wadim in cc,
> >
> > Hi Jagan,
> >
> > After this patch set apply, the phycore-rk3288 board's SPL size is
> > overflow:
> >
> >        arm:  +   phycore-rk3288
> > +Error: SPL image is too large (size 0x9000 than 0x8000)
> > +Error: Bad parameters for image type
> >
> > Maybe we need to enable the TPL for this board? @Wadim
>
> I would like it to keep the SPL for the phyCORE board. In this thread
> [1] I pointed out that you can drop the phycore_init() function that was
> sometimes blowing up the size of the phyCORE SPL image. So if there is
> no new other feature that increases the SPL size, we can just remove the
> code and the SPL should fit again. If you like I can take a look at this
> next week.

If not, maybe we can disable BINMAN for this board? I'm sure it can
revert since there would be a need to move TPL in future.