[PATCH] imx: imx8qxp_mek: update README

[Peng Fan]

> Subject: RE: [PATCH] imx: imx8qxp_mek: update README
> 
> > Subject: Re: [PATCH] imx: imx8qxp_mek: update README
> >
> > Hi Peng
> >
> > On Tue, Jan 7, 2020 at 10:33 PM Peng Fan <peng.fan at nxp.com> wrote:
> > >
> > > Update README to use 4.19.35_1.1.0 released firmware images.
> >
> > I have tried the same here and I still get a hang with Ethernet. If I
> > manually remove Ethernet support from the defconfig then I am able to
> > get into the U-Boot prompt.
> >
> > Could you please share your U-Boot logs?
> 
> I not have a board at hand. Will paste the log tomorrow.

The ipg clk patch needs to be reverted for now. Anyway the log as below:

U-Boot SPL 2020.01-00025-gedb89b239c-dirty (Jan 08 2020 - 09:50:22 +0800)
Normal Boot
WDT:   Not found!
Trying to boot from MMC2_2
Load image from MMC/SD 0x46800


U-Boot 2020.01-00025-gedb89b239c-dirty (Jan 08 2020 - 09:50:22 +0800)

CPU:   NXP i.MX8QXP RevB A35 at 1200 MHz at 19C

Model: Freescale i.MX8QXP MEK
Board: iMX8QXP MEK
Build: SCFW 550f3079, SECO-FW d7523fe8, ATF f900faa
Boot:  SD1
DRAM:  3 GiB
Failed to enable ipg clk
MMC:   FSL_SDHC: 0, FSL_SDHC: 1
Loading Environment from MMC... *** Warning - bad CRC, using default environment

In:    serial at 5a060000
Out:   serial at 5a060000
Err:   serial at 5a060000
Net:   Failed to enable ipg clk

Warning: ethernet at 5b040000 using MAC address from ROM
eth0: ethernet at 5b040000
Hit any key to stop autoboot:  0
=>

Regards,
Peng.

> 
> Thanks,
> Peng.
> 
> >
> > I use a i.MX8QXP mek with B0 silicon and revC1.
> >
> > Thanks