[PATCH 1/3] mtd: rawnand: denali-spl: Add missing hardware init

[Marek Vasut]

On 1/9/20 12:29 PM, Masahiro Yamada wrote:
> On Thu, Jan 9, 2020 at 7:08 PM Marek Vasut <marex at denx.de> wrote:
>>
>> While the Denali NAND is initialized by the BootROM in SPL, there
>> are still a couple of settings which are missing. These can trigger
>> subtle corruption of the data read out of the NAND. Fill these
>> settings in just like they are filled in by the full Denali NAND
>> driver in denali_hw_init().
>>
>> Signed-off-by: Marek Vasut <marex at denx.de>
>> Cc: Masahiro Yamada <yamada.masahiro at socionext.com>
>> ---
>>  drivers/mtd/nand/raw/denali_spl.c | 7 +++++++
>>  1 file changed, 7 insertions(+)
>>
>> diff --git a/drivers/mtd/nand/raw/denali_spl.c b/drivers/mtd/nand/raw/denali_spl.c
>> index dbaba3cab2..b8b29812aa 100644
>> --- a/drivers/mtd/nand/raw/denali_spl.c
>> +++ b/drivers/mtd/nand/raw/denali_spl.c
>> @@ -173,6 +173,13 @@ void nand_init(void)
>>         page_size = readl(denali_flash_reg + DEVICE_MAIN_AREA_SIZE);
>>         oob_size = readl(denali_flash_reg + DEVICE_SPARE_AREA_SIZE);
>>         pages_per_block = readl(denali_flash_reg + PAGES_PER_BLOCK);
>> +
>> +       /* Do as denali_hw_init() does. */
>> +       writel(CONFIG_NAND_DENALI_SPARE_AREA_SKIP_BYTES,
>> +              denali_flash_reg + SPARE_AREA_SKIP_BYTES);
>> +       writel(0x0F, denali_flash_reg + RB_PIN_ENABLED);
>> +       writel(CHIP_EN_DONT_CARE__FLAG, denali_flash_reg + CHIP_ENABLE_DONT_CARE);
>> +       writel(0xffff, denali_flash_reg + SPARE_AREA_MARKER);
>>  }
>>
> 
> You need this because SOCFPGA SPL resets the nand controller, correct?
> 
> https://github.com/u-boot/u-boot/blob/v2020.01/arch/arm/mach-socfpga/spl_gen5.c#L89

Yes. The driver should init the hardware correctly and fully, which it
does not do without this patch.