[PATCH 2/3] sunxi: Add Libre Computer ALL-H3-IT H5 board

[Chen-Yu Tsai]

From: Chen-Yu Tsai <wens at csie.org>

The Libre Computer ALL-H3-IT board is a small single board computer that
is roughly the same size as the Raspberry Pi Zero, or around 20% smaller
than a credit card.

The board features:

  - H2, H3, or H5 SoC from Allwinner
  - 2 DDR3 DRAM chips
  - Realtek RTL8821CU based WiFi module
  - 128 Mbit SPI-NOR flash
  - micro-SD card slot
  - micro HDMI video output
  - FPC connector for camera sensor module
  - generic Raspberri-Pi style 40 pin GPIO header
  - additional pin headers for extra USB host ports, ananlog audio and
    IR receiver

Only H5 variant test samples were made available, but the vendor does
have plans to include at least an H3 variant. Thus the device tree is
split much like the ALL-H3-CC, with a common dtsi file for the board
design, and separate dts files including the common board file and the
SoC dtsi file. The other variants will be added as they are made
available.

The device tree was synced over from the Linux kernel, along with other
H3/H5 changes, in a previous patch. Thus only the defconfig and an entry
to the MAINTAINERS file is added.

Signed-off-by: Chen-Yu Tsai <wens at csie.org>
---
 board/sunxi/MAINTAINERS                  |  5 +++++
 configs/libretech_all_h3_it_h5_defconfig | 22 ++++++++++++++++++++++
 2 files changed, 27 insertions(+)
 create mode 100644 configs/libretech_all_h3_it_h5_defconfig

diff --git a/board/sunxi/MAINTAINERS b/board/sunxi/MAINTAINERS
index 4a89bb0e7b7e..ed620ade766c 100644
--- a/board/sunxi/MAINTAINERS
+++ b/board/sunxi/MAINTAINERS
@@ -318,6 +318,11 @@ F:	configs/libretech_all_h3_cc_h2_plus_defconfig
 F:	configs/libretech_all_h3_cc_h3_defconfig
 F:	configs/libretech_all_h3_cc_h5_defconfig
 
+LIBRETECH ALL-H3-IT BOARDS
+M:	Chen-Yu Tsai <wens at csie.org>
+S:	Maintained
+F:	configs/libretech_all_h3_it_h5_defconfig
+
 NANOPI-M1 BOARD
 M:	Mylène Josserand <mylene.josserand at free-electrons.com>
 S:	Maintained
diff --git a/configs/libretech_all_h3_it_h5_defconfig b/configs/libretech_all_h3_it_h5_defconfig
new file mode 100644
index 000000000000..df13f4a0d307
--- /dev/null
+++ b/configs/libretech_all_h3_it_h5_defconfig
@@ -0,0 +1,22 @@
+CONFIG_ARM=y
+CONFIG_ARCH_SUNXI=y
+CONFIG_NR_DRAM_BANKS=1
+CONFIG_SPL=y
+CONFIG_MACH_SUN50I_H5=y
+CONFIG_DRAM_CLK=672
+CONFIG_MMC_SUNXI_SLOT_EXTRA=2
+CONFIG_SPL_SPI_SUNXI=y
+# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
+CONFIG_USE_PREBOOT=y
+CONFIG_SYS_SPI_U_BOOT_OFFS=0x8000
+# CONFIG_SPL_DOS_PARTITION is not set
+# CONFIG_SPL_EFI_PARTITION is not set
+CONFIG_DEFAULT_DEVICE_TREE="sun50i-h5-libretech-all-h3-it"
+CONFIG_SYS_RELOC_GD_ENV_ADDR=y
+CONFIG_DM_SPI_FLASH=y
+CONFIG_SPI_FLASH_XMC=y
+CONFIG_SPI=y
+CONFIG_DM_SPI=y
+CONFIG_USB_EHCI_HCD=y
+CONFIG_USB_OHCI_HCD=y
+CONFIG_SYS_USB_EVENT_POLL_VIA_INT_QUEUE=y
-- 
2.24.1