[PATCH v3 08/10] arm: mvebu: enable working default boot support

[Joel Johnson]

With the move to driver model usage, ensure that the required driver
support for SPI and MMC booting is available in SPL.

Tested on SolidRun ClearFog devices.

Signed-off-by: Joel Johnson <mrjoel at lixil.net>
---

v2 changes:
  - change "select" for ENV_IS_IN_X to "imply" to allow disabling the
    default env location and configuring a different one if desired
  - remove SPL_DM_GPIO from defconfig, only include if needed for
    MMC booting
v2 changes:
  - none

---
 arch/arm/mach-mvebu/Kconfig | 10 ++++++++++
 configs/clearfog_defconfig  |  1 -
 2 files changed, 10 insertions(+), 1 deletion(-)

diff --git a/arch/arm/mach-mvebu/Kconfig b/arch/arm/mach-mvebu/Kconfig
index 161dee937f..32191e7157 100644
--- a/arch/arm/mach-mvebu/Kconfig
+++ b/arch/arm/mach-mvebu/Kconfig
@@ -235,9 +235,19 @@ choice
 
 config MVEBU_SPL_BOOT_DEVICE_SPI
 	bool "SPI NOR flash"
+	imply ENV_IS_IN_SPI_FLASH
+	select SPL_DM_SPI
+	select SPL_MTD_SUPPORT
+	select SPL_SPI_FLASH_SUPPORT
+	select SPL_SPI_LOAD
+	select SPL_SPI_SUPPORT
 
 config MVEBU_SPL_BOOT_DEVICE_MMC
 	bool "SDIO/MMC card"
+	imply ENV_IS_IN_MMC
+	# GPIO required for SD card presence detection line
+	select SPL_DM_GPIO
+	select SPL_DM_MMC
 	select SPL_LIBDISK_SUPPORT
 
 config MVEBU_SPL_BOOT_DEVICE_SATA
diff --git a/configs/clearfog_defconfig b/configs/clearfog_defconfig
index 53a51794f0..e2399a9739 100644
--- a/configs/clearfog_defconfig
+++ b/configs/clearfog_defconfig
@@ -27,7 +27,6 @@ CONFIG_SYS_CONSOLE_INFO_QUIET=y
 # CONFIG_DISPLAY_BOARDINFO is not set
 CONFIG_DISPLAY_BOARDINFO_LATE=y
 CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_DATA_PART_OFFSET=0x1
-CONFIG_SPL_DM_GPIO=y
 CONFIG_SPL_I2C_SUPPORT=y
 CONFIG_CMD_TLV_EEPROM=y
 CONFIG_SPL_CMD_TLV_EEPROM=y
-- 
2.20.1