[PATCH v4 06/12] arm: mvebu: clearfog: Add option for 2.5 Gbps SFP

[Joel Johnson]

While newer Linux kernels provide autoconfiguration of SFP, provide
an option for setting in U-Boot Kconfig for use prior to booting.

Signed-off-by: Joel Johnson <mrjoel at lixil.net>

---

v2 changes:
  - fixed help indentation
v3 changes:
  - none
v4 changes:
  - adjust static SerDes configuration at runtime instead of #ifdef

---
 board/solidrun/clearfog/Kconfig    | 7 +++++++
 board/solidrun/clearfog/clearfog.c | 3 +++
 2 files changed, 10 insertions(+)

diff --git a/board/solidrun/clearfog/Kconfig b/board/solidrun/clearfog/Kconfig
index 936d5918f8..c910e17093 100644
--- a/board/solidrun/clearfog/Kconfig
+++ b/board/solidrun/clearfog/Kconfig
@@ -15,4 +15,11 @@ config TARGET_CLEARFOG_BASE
 	  detection via additional EEPROM hardware. This option enables selecting
 	  the Base variant for older hardware revisions.
 
+config CLEARFOG_SFP_25GB
+	bool "Enable 2.5 Gbps mode for SFP"
+	help
+	  Set the SFP module connection to support 2.5 Gbps transfer speed for the
+	  SGMII connection (requires a supporting SFP). By default, transfer speed
+	  of 1.25 Gbps is used, suitable for a more common 1 Gbps SFP module.
+
 endmenu
diff --git a/board/solidrun/clearfog/clearfog.c b/board/solidrun/clearfog/clearfog.c
index 4019e37016..6c5b9a784f 100644
--- a/board/solidrun/clearfog/clearfog.c
+++ b/board/solidrun/clearfog/clearfog.c
@@ -59,6 +59,9 @@ void config_static_serdes_map(void)
 		board_serdes_map[4].serdes_speed = SERDES_SPEED_5_GBPS;
 		board_serdes_map[4].serdes_mode = SERDES_DEFAULT_MODE;
 	}
+
+	if (IS_ENABLED(CONFIG_CLEARFOG_SFP_25GB))
+		board_serdes_map[5].serdes_speed = SERDES_SPEED_3_125_GBPS;
 }
 
 int hws_board_topology_load(struct serdes_map **serdes_map_array, u8 *count)
-- 
2.20.1