[PATCH v5 00/12] ClearFog Base static variant support

[Joel Johnson]

This patch series adds support for ClearFog Base static configuration,
as well as updating and fixing the ClearFog support for MMC and SPI
booting.

v2 changes:
  - updated against, and dependent on, https://patchwork.ozlabs.org/cover/1200324
v3 changes:
  - rebased against ClearFog runtime TLV EEPROM changes merged into mvebu/master
v4
  - adjust static SerDes configuration at runtime instead of #ifdef
v5
  - distinguish build-only config changes (SFP and PCIe/SATA) from
    runtime detectable config changes
  - retested SATA mode in PCIe slot with swap rx changes, confirmed
    working as presently patched. Only tested with ClearFog Base which
    only provides single channel, but Pro mechanism is parallel.


Joel Johnson (12):
  arm: mvebu: fix SerDes table alignment
  arm: mvebu: solidrun: remove hardcoded DTS MAC address
  arm: mvebu: clearfog: use Pro name by default
  arm: mvebu: clearfog: initial ClearFog Base variant
  arm: mvebu: clearfog: Add option for 2.5 Gbps SFP
  arm: mvebu: clearfog: Add SATA mode flags
  arm: mvebu: clearfog: Unify DT selection paths
  arm: mvebu: clearfog: add SPI offsets
  arm: mvebu: enable working default boot support
  arm: mvebu: clearfog: move ENV params to Kconfig
  arm: mvebu: clearfog: don't always use SPL MMC
  arm: mvebu: clearfog: Use Pro DT by default

 .../arm/dts/armada-38x-solidrun-microsom.dtsi |  1 -
 arch/arm/mach-mvebu/Kconfig                   | 13 ++++
 .../serdes/a38x/high_speed_env_spec.c         |  6 +-
 board/solidrun/clearfog/Kconfig               | 62 +++++++++++++++++++
 board/solidrun/clearfog/clearfog.c            | 53 +++++++++++++---
 configs/clearfog_defconfig                    |  4 --
 include/configs/clearfog.h                    |  1 -
 7 files changed, 124 insertions(+), 16 deletions(-)
 create mode 100644 board/solidrun/clearfog/Kconfig

-- 
2.20.1