[PATCH v2] net: zynq: Add support for mdio bus address decoding

[Michal Simek]

Xilinx DTS files are using two way how to describe ethernet phy.

The first (already supported) has phy as subnode of gem node.
eth {
        phy-handle = <&phy0>;
         phy0: ethernet-phy at 21 {
                ...
        };
};

The second has mdio subnode (with mdio name) which has phy subnode. This
structure allow hadling MDIO reset signal (based on Linux mdio.yaml)
eth {
        phy-handle = <&phy0>;
        mdio {
                phy0: ethernet-phy at 21 {
                        ...
                };
        };
};

This patch adds support for the second case where mdio subnode
is found driver will look at its parent to find out which gem is handling
MDIO bus.

Signed-off-by: Michal Simek <michal.simek at xilinx.com>
---

Changes in v2:
- update commit message

 drivers/net/zynq_gem.c | 3 +++
 1 file changed, 3 insertions(+)

diff --git a/drivers/net/zynq_gem.c b/drivers/net/zynq_gem.c
index 3e227725022d..fece077066df 100644
--- a/drivers/net/zynq_gem.c
+++ b/drivers/net/zynq_gem.c
@@ -846,6 +846,9 @@ static int zynq_gem_of_to_plat(struct udevice *dev)
 							  SPEED_1000);
 
 		parent = ofnode_get_parent(phandle_args.node);
+		if (ofnode_name_eq(parent, "mdio"))
+			parent = ofnode_get_parent(parent);
+
 		addr = ofnode_get_addr(parent);
 		if (addr != FDT_ADDR_T_NONE) {
 			debug("MDIO bus not found %s\n", dev->name);
-- 
2.33.1