[PATCH v2] net: zynq: Add support for PHY configuration in SGMII mode

[Michal Simek]

SGMII configuration depends on proper GT setting that's why when node has
phys property call PSGTR driver to configure it properly.

Signed-off-by: Michal Simek <michal.simek at xilinx.com>
---

Changes in v2:
- Handle also cases where phy reference doesn't exist which means
  that u-boot doesn't need to configure it (configured via psu_init for
  example)
- Error out where reference exists but driver is not compiled in - reported
  by Sean

 drivers/net/zynq_gem.c | 19 +++++++++++++++++++
 1 file changed, 19 insertions(+)

diff --git a/drivers/net/zynq_gem.c b/drivers/net/zynq_gem.c
index 5cbe8d28304b..ac658cd6b5e9 100644
--- a/drivers/net/zynq_gem.c
+++ b/drivers/net/zynq_gem.c
@@ -12,6 +12,7 @@
 #include <common.h>
 #include <cpu_func.h>
 #include <dm.h>
+#include <generic-phy.h>
 #include <log.h>
 #include <net.h>
 #include <netdev.h>
@@ -716,6 +717,24 @@ static int zynq_gem_probe(struct udevice *dev)
 	struct zynq_gem_priv *priv = dev_get_priv(dev);
 	int ret;
 
+	if (priv->interface == PHY_INTERFACE_MODE_SGMII) {
+		struct phy phy;
+
+		ret = generic_phy_get_by_index(dev, 0, &phy);
+		if (!ret) {
+			ret = generic_phy_init(&phy);
+			if (ret)
+				return ret;
+
+			ret = generic_phy_power_on(&phy);
+			if (ret)
+				return ret;
+		} else if (ret != -ENOENT) {
+			debug("could not get phy (err %d)\n", ret);
+			return ret;
+		}
+	}
+
 	ret = zynq_gem_reset_init(dev);
 	if (ret)
 		return ret;
-- 
2.34.1