[PATCH] arm: stm32mp: stm32prog: always flush DFU on start command for uart

[Patrick DELAUNAY]

Hi,

On 12/11/20 1:36 PM, Patrick Delaunay wrote:
> From: Patrick Delaunay <patrick.delaunay at st.com>
>
> Remove the test on data->dfu_seq, because dfu_seq=0 not only when
> the DFU is not started (mask with 0xffff). This flush is mandatory
> as the final treatment, common with USB, is done in DFU callback.
>
> This patch avoids issue if the received length is a multiple of
> the DFU packet.
>
> For example if size of bootfs partition is egual to 0x4000000,
> data->dfu_seq=0 at the end of the partition, the flush it not
> requested and the phase is not increased in the callback.
> U-Boot continue to request the bootfs in the next GetPhase command.
>
> Fixes: 468f0508b58b ("stm32mp: stm32prog: add serial link support")
> Signed-off-by: Patrick Delaunay <patrick.delaunay at st.com>
> Signed-off-by: Patrick Delaunay <patrick.delaunay at foss.st.com>
> ---
>
>   .../mach-stm32mp/cmd_stm32prog/stm32prog_serial.c   | 13 ++++++-------
>   1 file changed, 6 insertions(+), 7 deletions(-)
>

Applied to u-boot-stm/master, thanks!

Regards

Patrick