[PATCH] spi: zynqmp_gqspi: support dual and quad mode
Brandon Maier
brandon.maier at rockwellcollins.com
Fri Jan 15 22:30:20 CET 2021
The dm_spi_ops.xfer() API does not support dual and quad SPI modes. It
also doesn't allow the zynqmp_gqspi driver to calculate the correct
number of dummy cycles for some NOR ops (as doing so also requires the
buswidth).
Port the zynqmp_gqspi driver to spi_controller_mem_ops, which gives us
the buswidth values to correctly support all SNOR_PROTO_X_X_X commands
and to properly calculate dummy cycles.
Signed-off-by: Brandon Maier <brandon.maier at rockwellcollins.com>
CC: jagan at amarulasolutions.com
CC: michal.simek at xilinx.com
---
drivers/spi/zynqmp_gqspi.c | 164 ++++++++++++++++---------------------
1 file changed, 70 insertions(+), 94 deletions(-)
diff --git a/drivers/spi/zynqmp_gqspi.c b/drivers/spi/zynqmp_gqspi.c
index efcbd0557f..e1fd551f68 100644
--- a/drivers/spi/zynqmp_gqspi.c
+++ b/drivers/spi/zynqmp_gqspi.c
@@ -16,6 +16,7 @@
#include <malloc.h>
#include <memalign.h>
#include <spi.h>
+#include <spi-mem.h>
#include <ubi_uboot.h>
#include <wait_bit.h>
#include <dm/device_compat.h>
@@ -171,8 +172,7 @@ struct zynqmp_qspi_priv {
unsigned int len;
int bytes_to_transfer;
int bytes_to_receive;
- unsigned int is_inst;
- unsigned int cs_change:1;
+ const struct spi_mem_op *op;
};
static int zynqmp_qspi_of_to_plat(struct udevice *bus)
@@ -221,6 +221,21 @@ static u32 zynqmp_qspi_bus_select(struct zynqmp_qspi_priv *priv)
return gqspi_fifo_reg;
}
+static u32 zynqmp_qspi_genfifo_mode(u8 buswidth)
+{
+ switch (buswidth) {
+ case 1:
+ return GQSPI_SPI_MODE_SPI;
+ case 2:
+ return GQSPI_SPI_MODE_DUAL_SPI;
+ case 4:
+ return GQSPI_SPI_MODE_QSPI;
+ default:
+ debug("Unsupported bus width %u\n", buswidth);
+ return GQSPI_SPI_MODE_SPI;
+ }
+}
+
static void zynqmp_qspi_fill_gen_fifo(struct zynqmp_qspi_priv *priv,
u32 gqspi_fifo_reg)
{
@@ -445,21 +460,42 @@ static int zynqmp_qspi_fill_tx_fifo(struct zynqmp_qspi_priv *priv, u32 size)
static void zynqmp_qspi_genfifo_cmd(struct zynqmp_qspi_priv *priv)
{
+ const struct spi_mem_op *op = priv->op;
u32 gen_fifo_cmd;
- u32 bytecount = 0;
+ u8 i, dummy_cycles, addr;
+
+ /* Send opcode */
+ gen_fifo_cmd = zynqmp_qspi_bus_select(priv);
+ gen_fifo_cmd |= zynqmp_qspi_genfifo_mode(op->cmd.buswidth);
+ gen_fifo_cmd |= GQSPI_GFIFO_TX;
+ gen_fifo_cmd |= op->cmd.opcode;
+ zynqmp_qspi_fill_gen_fifo(priv, gen_fifo_cmd);
+
+ /* Send address */
+ for (i = 0; i < op->addr.nbytes; i++) {
+ addr = op->addr.val >> (8 * (op->addr.nbytes - i - 1));
- while (priv->len) {
gen_fifo_cmd = zynqmp_qspi_bus_select(priv);
- gen_fifo_cmd |= GQSPI_GFIFO_TX | GQSPI_SPI_MODE_SPI;
- gen_fifo_cmd |= *(u8 *)priv->tx_buf;
- bytecount++;
- priv->len--;
- priv->tx_buf = (u8 *)priv->tx_buf + 1;
+ gen_fifo_cmd |= zynqmp_qspi_genfifo_mode(op->addr.buswidth);
+ gen_fifo_cmd |= GQSPI_GFIFO_TX;
+ gen_fifo_cmd |= addr;
debug("GFIFO_CMD_Cmd = 0x%x\n", gen_fifo_cmd);
zynqmp_qspi_fill_gen_fifo(priv, gen_fifo_cmd);
}
+
+ /* Send dummy */
+ if (op->dummy.nbytes) {
+ dummy_cycles = op->dummy.nbytes * 8 / op->dummy.buswidth;
+
+ gen_fifo_cmd = zynqmp_qspi_bus_select(priv);
+ gen_fifo_cmd |= zynqmp_qspi_genfifo_mode(op->dummy.buswidth);
+ gen_fifo_cmd &= ~(GQSPI_GFIFO_TX | GQSPI_GFIFO_RX);
+ gen_fifo_cmd |= GQSPI_GFIFO_DATA_XFR_MASK;
+ gen_fifo_cmd |= dummy_cycles;
+ zynqmp_qspi_fill_gen_fifo(priv, gen_fifo_cmd);
+ }
}
static u32 zynqmp_qspi_calc_exp(struct zynqmp_qspi_priv *priv,
@@ -496,11 +532,10 @@ static int zynqmp_qspi_genfifo_fill_tx(struct zynqmp_qspi_priv *priv)
int ret = 0;
gen_fifo_cmd = zynqmp_qspi_bus_select(priv);
+ gen_fifo_cmd |= zynqmp_qspi_genfifo_mode(priv->op->data.buswidth);
gen_fifo_cmd |= GQSPI_GFIFO_TX |
GQSPI_GFIFO_DATA_XFR_MASK;
- gen_fifo_cmd |= GQSPI_SPI_MODE_SPI;
-
while (priv->len) {
len = zynqmp_qspi_calc_exp(priv, &gen_fifo_cmd);
zynqmp_qspi_fill_gen_fifo(priv, gen_fifo_cmd);
@@ -574,11 +609,10 @@ static int zynqmp_qspi_genfifo_fill_rx(struct zynqmp_qspi_priv *priv)
u32 actuallen = priv->len;
gen_fifo_cmd = zynqmp_qspi_bus_select(priv);
+ gen_fifo_cmd |= zynqmp_qspi_genfifo_mode(priv->op->data.buswidth);
gen_fifo_cmd |= GQSPI_GFIFO_RX |
GQSPI_GFIFO_DATA_XFR_MASK;
- gen_fifo_cmd |= GQSPI_SPI_MODE_SPI;
-
/*
* Check if receive buffer is aligned to 4 byte and length
* is multiples of four byte as we are using dma to receive.
@@ -595,62 +629,6 @@ static int zynqmp_qspi_genfifo_fill_rx(struct zynqmp_qspi_priv *priv)
return zynqmp_qspi_start_dma(priv, gen_fifo_cmd, buf);
}
-static int zynqmp_qspi_start_transfer(struct zynqmp_qspi_priv *priv)
-{
- int ret = 0;
-
- if (priv->is_inst) {
- if (priv->tx_buf)
- zynqmp_qspi_genfifo_cmd(priv);
- else
- return -EINVAL;
- } else {
- if (priv->tx_buf)
- ret = zynqmp_qspi_genfifo_fill_tx(priv);
- else if (priv->rx_buf)
- ret = zynqmp_qspi_genfifo_fill_rx(priv);
- else
- return -EINVAL;
- }
- return ret;
-}
-
-static int zynqmp_qspi_transfer(struct zynqmp_qspi_priv *priv)
-{
- static unsigned int cs_change = 1;
- int status = 0;
-
- debug("%s\n", __func__);
-
- while (1) {
- /* Select the chip if required */
- if (cs_change)
- zynqmp_qspi_chipselect(priv, 1);
-
- cs_change = priv->cs_change;
-
- if (!priv->tx_buf && !priv->rx_buf && priv->len) {
- status = -EINVAL;
- break;
- }
-
- /* Request the transfer */
- if (priv->len) {
- status = zynqmp_qspi_start_transfer(priv);
- priv->is_inst = 0;
- if (status < 0)
- break;
- }
-
- if (cs_change)
- /* Deselect the chip */
- zynqmp_qspi_chipselect(priv, 0);
- break;
- }
-
- return status;
-}
-
static int zynqmp_qspi_claim_bus(struct udevice *dev)
{
struct udevice *bus = dev->parent;
@@ -673,45 +651,43 @@ static int zynqmp_qspi_release_bus(struct udevice *dev)
return 0;
}
-int zynqmp_qspi_xfer(struct udevice *dev, unsigned int bitlen, const void *dout,
- void *din, unsigned long flags)
+static int zynqmp_qspi_exec_op(struct spi_slave *slave,
+ const struct spi_mem_op *op)
{
- struct udevice *bus = dev->parent;
- struct zynqmp_qspi_priv *priv = dev_get_priv(bus);
+ struct zynqmp_qspi_priv *priv = dev_get_priv(slave->dev->parent);
+ int ret;
- debug("%s: priv: 0x%08lx bitlen: %d dout: 0x%08lx ", __func__,
- (unsigned long)priv, bitlen, (unsigned long)dout);
- debug("din: 0x%08lx flags: 0x%lx\n", (unsigned long)din, flags);
+ priv->op = op;
+ priv->tx_buf = op->data.buf.out;
+ priv->rx_buf = op->data.buf.in;
+ priv->len = op->data.nbytes;
- priv->tx_buf = dout;
- priv->rx_buf = din;
- priv->len = bitlen / 8;
+ zynqmp_qspi_chipselect(priv, 1);
- /*
- * Assume that the beginning of a transfer with bits to
- * transmit must contain a device command.
- */
- if (dout && flags & SPI_XFER_BEGIN)
- priv->is_inst = 1;
- else
- priv->is_inst = 0;
+ /* Send opcode, addr, dummy */
+ zynqmp_qspi_genfifo_cmd(priv);
- if (flags & SPI_XFER_END)
- priv->cs_change = 1;
- else
- priv->cs_change = 0;
+ /* Request the transfer */
+ if (op->data.dir == SPI_MEM_DATA_IN)
+ ret = zynqmp_qspi_genfifo_fill_rx(priv);
+ else if (op->data.dir == SPI_MEM_DATA_OUT)
+ ret = zynqmp_qspi_genfifo_fill_tx(priv);
- zynqmp_qspi_transfer(priv);
+ zynqmp_qspi_chipselect(priv, 0);
- return 0;
+ return ret;
}
+static const struct spi_controller_mem_ops zynqmp_qspi_mem_ops = {
+ .exec_op = zynqmp_qspi_exec_op,
+};
+
static const struct dm_spi_ops zynqmp_qspi_ops = {
.claim_bus = zynqmp_qspi_claim_bus,
.release_bus = zynqmp_qspi_release_bus,
- .xfer = zynqmp_qspi_xfer,
.set_speed = zynqmp_qspi_set_speed,
.set_mode = zynqmp_qspi_set_mode,
+ .mem_ops = &zynqmp_qspi_mem_ops,
};
static const struct udevice_id zynqmp_qspi_ids[] = {
--
2.29.1
More information about the U-Boot
mailing list