[PATCH 2/2] video: dw_mipi_dsi: update log of dphy_enable

[Patrick Delaunay]

From: Yannick Fertre <yannick.fertre at foss.st.com>

The DSI phy can be turned on from the DSI digital interface in
the dphy_enable() function or from a dedicated DSI phy "wrapper"
in phy_ops->init() function. If the STM32MP1 case, the wrapper
is used then the dphy_enable() "warning" traces are not relevant.

This patch moves these "warning" traces to "debug" traces so
they are still available for DSI phy based on the digital
interface in debug logging mode, but not there in normal mode
for both cases.
Note: The related Linux kernel driver uses a "debug"
message too.

Signed-off-by: Yannick Fertre <yannick.fertre at foss.st.com>
Signed-off-by: Patrick Delaunay <patrick.delaunay at foss.st.com>
---

 drivers/video/dw_mipi_dsi.c | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/video/dw_mipi_dsi.c b/drivers/video/dw_mipi_dsi.c
index a5beed3514..9ae09eec12 100644
--- a/drivers/video/dw_mipi_dsi.c
+++ b/drivers/video/dw_mipi_dsi.c
@@ -721,15 +721,15 @@ static void dw_mipi_dsi_dphy_enable(struct dw_mipi_dsi *dsi)
 	ret = readl_poll_timeout(dsi->base + DSI_PHY_STATUS, val,
 				 val & PHY_LOCK, PHY_STATUS_TIMEOUT_US);
 	if (ret)
-		dev_warn(dsi->dsi_host.dev,
-			 "failed to wait phy lock state\n");
+		dev_dbg(dsi->dsi_host.dev,
+			"failed to wait phy lock state\n");
 
 	ret = readl_poll_timeout(dsi->base + DSI_PHY_STATUS,
 				 val, val & PHY_STOP_STATE_CLK_LANE,
 				 PHY_STATUS_TIMEOUT_US);
 	if (ret)
-		dev_warn(dsi->dsi_host.dev,
-			 "failed to wait phy clk lane stop state\n");
+		dev_dbg(dsi->dsi_host.dev,
+			"failed to wait phy clk lane stop state\n");
 }
 
 static void dw_mipi_dsi_clear_err(struct dw_mipi_dsi *dsi)
-- 
2.17.1