[PATCH 00/11] imx: ventana: convert Gateworks Ventana to dm

[Tim Harvey]

On Mon, Mar 1, 2021 at 2:33 PM Tim Harvey <tharvey at gateworks.com> wrote:
>
> This is the first series converting the IMX6 basd Gateworks Ventana
> boards to driver-model.
>
> This series resolves some issues with NAND SPL (non DM SPL) in order
> to read the FIT image. Additionally it covers conversions to DM_USB,
> DM_MMC, DM_MTD, and DM_SPI.
>
> Remaining items are DM_PCI and DM_ETH which I'm still working through.
>
> Tim
>
> Tim Harvey (11):
>   spl: fit: nand: skip bad block handling if NAND chip not fully defined
>   spl: fit: nand: allow for non-page-aligned elements
>   dt-bindings: add tda1997x and bindings
>   imx: ventana: add Gateworks Ventana dts
>   arm: dts: imx6qdl-gw*: add dr_mode prop to dt to avoid error
>   imx: ventana: convert U-Boot to OF_CONTROL using FIT image
>   imx: ventana: add pinctrl and remove unneeded UART init and config
>   imx: ventana: enable dm support for USB
>   imx: ventana: enable dm support for MMC and SATA
>   imx: ventana: enable dm for MTD and NAND
>   imx: ventana: enable dm for SPI
>

Stefano,

I'm ready to send a v2 of this patch series. Have you had a chance to
review these yet? Tom reviewed the first three and I have an update to
the commit log pending to state what Linux kernel the tda1997x
bindings come from but I have not had any comments on the rest of the
series.

There may have been an issue with my mail server when I sent them so
they may have got missed.

Best Regards,

Tim