[PATCH v3 20/20] configs: j7200_evm_a72: Enhance bootcmd to configure ethernet PHY

[Kishon Vijay Abraham I]

Update the default BOOTCOMMAND to provide an automatic and easier way
to configure ethernet PHY before loading the firmware.

Signed-off-by: Kishon Vijay Abraham I <kishon at ti.com>
---
 configs/j7200_evm_a72_defconfig | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/configs/j7200_evm_a72_defconfig b/configs/j7200_evm_a72_defconfig
index bf78b36d22..5929bba82a 100644
--- a/configs/j7200_evm_a72_defconfig
+++ b/configs/j7200_evm_a72_defconfig
@@ -30,7 +30,7 @@ CONFIG_SPL_LOAD_FIT=y
 CONFIG_SPL_LOAD_FIT_ADDRESS=0x81000000
 # CONFIG_USE_SPL_FIT_GENERATOR is not set
 CONFIG_OF_BOARD_SETUP=y
-CONFIG_BOOTCOMMAND="run findfdt; run envboot; run init_${boot}; run boot_rprocs; run get_kern_${boot}; run get_fdt_${boot}; run get_overlay_${boot}; run run_kern"
+CONFIG_BOOTCOMMAND="run findfdt; run envboot; run init_${boot}; run main_cpsw0_qsgmii_phyinit; run boot_rprocs; run get_kern_${boot}; run get_fdt_${boot}; run get_overlay_${boot}; run run_kern"
 CONFIG_LOGLEVEL=7
 CONFIG_SPL_BOARD_INIT=y
 CONFIG_SPL_SYS_MALLOC_SIMPLE=y
-- 
2.17.1