[PATCH v9 09/28] mtd: spi-nor-core: Fix address width on flash chips > 16MB

Pratyush Yadav p.yadav at ti.com
Wed May 5 11:41:19 CEST 2021


If a flash chip has more than 16MB capacity but its BFPT reports
BFPT_DWORD1_ADDRESS_BYTES_3_OR_4, the spi-nor framework defaults to 3.

The check in spi_nor_scan() doesn't catch it because addr_width did get
set. This fixes that check.

Ported from Kernel commit 324f78dfb442b82365548b657ec4e6974c677502.

Signed-off-by: Pratyush Yadav <p.yadav at ti.com>
---
 drivers/mtd/spi/spi-nor-core.c | 8 +++++---
 1 file changed, 5 insertions(+), 3 deletions(-)

diff --git a/drivers/mtd/spi/spi-nor-core.c b/drivers/mtd/spi/spi-nor-core.c
index a6625535a7..db918fc06f 100644
--- a/drivers/mtd/spi/spi-nor-core.c
+++ b/drivers/mtd/spi/spi-nor-core.c
@@ -2602,7 +2602,11 @@ int spi_nor_scan(struct spi_nor *nor)
 		/* already configured from SFDP */
 	} else if (info->addr_width) {
 		nor->addr_width = info->addr_width;
-	} else if (mtd->size > SZ_16M) {
+	} else {
+		nor->addr_width = 3;
+	}
+
+	if (nor->addr_width == 3 && mtd->size > SZ_16M) {
 #ifndef CONFIG_SPI_FLASH_BAR
 		/* enable 4-byte addressing if the device exceeds 16MiB */
 		nor->addr_width = 4;
@@ -2616,8 +2620,6 @@ int spi_nor_scan(struct spi_nor *nor)
 	if (ret < 0)
 		return ret;
 #endif
-	} else {
-		nor->addr_width = 3;
 	}
 
 	if (nor->addr_width > SPI_NOR_MAX_ADDR_WIDTH) {
-- 
2.30.0



More information about the U-Boot mailing list