[PATCH 8/8] mmc: sunxi: Use mmc_of_parse()

Jaehoon Chung jh80.chung at samsung.com
Tue May 25 03:43:11 CEST 2021


On 5/25/21 8:30 AM, Andre Przywara wrote:
> At the moment the Allwinner MMC driver parses the bus-width and
> non-removable DT properties itself, in the probe() routine.
> 
> There is actually a generic function provided by the MMC framework doing
> this job, also it parses more generic properties like broken-cd and
> advanced transfer modes.
> 
> Drop our own code and call mmc_of_parse() instead, to get all new
> features for free.
> 
> Signed-off-by: Andre Przywara <andre.przywara at arm.com>

Reviewed-by: Jaehoon Chung <jh80.chung at samsung.com>

Best Regards,
Jaehoon Chung
> ---
>  drivers/mmc/sunxi_mmc.c | 32 +++++++++++++++++---------------
>  1 file changed, 17 insertions(+), 15 deletions(-)
> 
> diff --git a/drivers/mmc/sunxi_mmc.c b/drivers/mmc/sunxi_mmc.c
> index 115b519546e..178b8cf106d 100644
> --- a/drivers/mmc/sunxi_mmc.c
> +++ b/drivers/mmc/sunxi_mmc.c
> @@ -37,7 +37,6 @@ struct sunxi_mmc_priv {
>  	uint32_t *mclkreg;
>  	unsigned fatal_err;
>  	struct gpio_desc cd_gpio;	/* Change Detect GPIO */
> -	int cd_inverted;		/* Inverted Card Detect */
>  	struct sunxi_mmc *reg;
>  	struct mmc_config cfg;
>  };
> @@ -612,12 +611,21 @@ static int sunxi_mmc_send_cmd(struct udevice *dev, struct mmc_cmd *cmd,
>  
>  static int sunxi_mmc_getcd(struct udevice *dev)
>  {
> +	struct mmc *mmc = mmc_get_mmc_dev(dev);
>  	struct sunxi_mmc_priv *priv = dev_get_priv(dev);
>  
> +	/* If polling, assume that the card is always present. */
> +	if ((mmc->cfg->host_caps & MMC_CAP_NONREMOVABLE) ||
> +	    (mmc->cfg->host_caps & MMC_CAP_NEEDS_POLL))
> +		return 1;
> +
>  	if (dm_gpio_is_valid(&priv->cd_gpio)) {
>  		int cd_state = dm_gpio_get_value(&priv->cd_gpio);
>  
> -		return cd_state ^ priv->cd_inverted;
> +		if (mmc->cfg->host_caps & MMC_CAP_CD_ACTIVE_HIGH)
> +			return !cd_state;
> +		else
> +			return cd_state;
>  	}
>  	return 1;
>  }
> @@ -649,23 +657,21 @@ static int sunxi_mmc_probe(struct udevice *dev)
>  	struct mmc_config *cfg = &plat->cfg;
>  	struct ofnode_phandle_args args;
>  	u32 *ccu_reg;
> -	int bus_width, ret;
> +	int ret;
>  
>  	cfg->name = dev->name;
> -	bus_width = dev_read_u32_default(dev, "bus-width", 1);
>  
>  	cfg->voltages = MMC_VDD_32_33 | MMC_VDD_33_34;
> -	cfg->host_caps = 0;
> -	if (bus_width == 8)
> -		cfg->host_caps |= MMC_MODE_8BIT;
> -	if (bus_width >= 4)
> -		cfg->host_caps |= MMC_MODE_4BIT;
> -	cfg->host_caps |= MMC_MODE_HS_52MHz | MMC_MODE_HS;
> +	cfg->host_caps = MMC_MODE_HS_52MHz | MMC_MODE_HS;
>  	cfg->b_max = CONFIG_SYS_MMC_MAX_BLK_COUNT;
>  
>  	cfg->f_min = 400000;
>  	cfg->f_max = 52000000;
>  
> +	ret = mmc_of_parse(dev, cfg);
> +	if (ret)
> +		return ret;
> +
>  	priv->reg = dev_read_addr_ptr(dev);
>  
>  	/* We don't have a sunxi clock driver so find the clock address here */
> @@ -691,17 +697,13 @@ static int sunxi_mmc_probe(struct udevice *dev)
>  		return ret;
>  
>  	/* This GPIO is optional */
> -	if (!dev_read_bool(dev, "non-removable") &&
> -	    !gpio_request_by_name(dev, "cd-gpios", 0, &priv->cd_gpio,
> +	if (!gpio_request_by_name(dev, "cd-gpios", 0, &priv->cd_gpio,
>  				  GPIOD_IS_IN)) {
>  		int cd_pin = gpio_get_number(&priv->cd_gpio);
>  
>  		sunxi_gpio_set_pull(cd_pin, SUNXI_GPIO_PULL_UP);
>  	}
>  
> -	/* Check if card detect is inverted */
> -	priv->cd_inverted = dev_read_bool(dev, "cd-inverted");
> -
>  	upriv->mmc = &plat->mmc;
>  
>  	/* Reset controller */
> 



More information about the U-Boot mailing list