[PATCH v1 5/5] doc: board: Update Microchip MPFS Icicle Kit doc

[Bin Meng]

On Fri, Oct 22, 2021 at 4:58 PM Padmarao Begari
<padmarao.begari at microchip.com> wrote:
>
> UART1 uses for U-BOOT and Linux console instead of UART0 and

nits: s/U-BOOT/U-Boot

> UART0 is reserved for Hart Software Services(HSS).
>
> Signed-off-by: Padmarao Begari <padmarao.begari at microchip.com>
> ---
>  doc/board/microchip/mpfs_icicle.rst | 11 +++++++----
>  1 file changed, 7 insertions(+), 4 deletions(-)
>
> diff --git a/doc/board/microchip/mpfs_icicle.rst b/doc/board/microchip/mpfs_icicle.rst
> index c71c2f3cab..d7af542c0e 100644
> --- a/doc/board/microchip/mpfs_icicle.rst
> +++ b/doc/board/microchip/mpfs_icicle.rst
> @@ -18,8 +18,9 @@ The support for following drivers are already enabled:
>
>  1. NS16550 UART Driver.
>  2. Microchip Clock Driver.
> -3. Cadence MACB ethernet driver for networking support.
> -4. Cadence MMC Driver for eMMC/SD support.
> +3. Microchip I2C Driver.

nits: can we just insert this after the existing entries?

> +4. Cadence MACB ethernet driver for networking support.
> +5. Cadence MMC Driver for eMMC/SD support.
>
>  Booting from eMMC using HSS
>  ---------------------------
> @@ -214,7 +215,8 @@ GPT partition.
>  Booting
>  ~~~~~~~
>
> -You should see the U-Boot prompt on UART0.
> +You should see the U-Boot prompt on UART1.
> +(Note: UART0 is reserved for HSS)
>
>  Sample boot log from MPFS Icicle Kit
>  ''''''''''''''''''''''''''''''''''''
> @@ -451,7 +453,8 @@ copied payload and Linux image.
>
>      sudo dd if=<payload_binary> of=/dev/sdX2 bs=512
>
> -You should see the U-Boot prompt on UART0.
> +You should see the U-Boot prompt on UART1.
> +(Note: UART0 is reserved for HSS)
>
>  GUID type
>  ~~~~~~~~~

Otherwise,
Reviewed-by: Bin Meng <bmeng.cn at gmail.com>

Regards,
Bin