[PATCH] net: eth-phy: Handle gpio_request_by_name() return value

[Marek Vasut]

The gpio_request_by_name() returns zero in case of success, however the
conditional return value check in gpio_request_by_name() checks only for
(ret != -ENOENT) and if the condition is true, returns ret outright.

This leads to a situation where successful gpio_request_by_name() return
leads to immediate successful eth_phy_of_to_plat() return as well, and
to skipped parsing of "reset-assert-us" and "reset-deassert-us", so the
PHY driver operates with valid reset GPIO, but with assert/deassert times
set to default, which is 0, instead of the values from DT. This breaks
PHY reset.

Fix this by checking if return value is non-zero and then for this one
single allowed non-zero return value, -ENOENT.

Signed-off-by: Marek Vasut <marex at denx.de>
Cc: Ramon Fried <rfried.dev at gmail.com>
---
 drivers/net/eth-phy-uclass.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/net/eth-phy-uclass.c b/drivers/net/eth-phy-uclass.c
index c04bab944d6..a9b358ee234 100644
--- a/drivers/net/eth-phy-uclass.c
+++ b/drivers/net/eth-phy-uclass.c
@@ -138,7 +138,7 @@ static int eth_phy_of_to_plat(struct udevice *dev)
 	ret = gpio_request_by_name(dev, "reset-gpios", 0,
 				   &uc_priv->reset_gpio,
 				   GPIOD_IS_OUT);
-	if (ret != -ENOENT)
+	if (ret && ret != -ENOENT)
 		return ret;
 
 	uc_priv->reset_assert_delay = dev_read_u32_default(dev, "reset-assert-us", 0);
-- 
2.33.0