[PATCH v2 08/10] microblaze: add Kconfig symbol for the vector base address

[Ovidiu Panait]

MicroBlaze vector base address is configurable (hdl C_BASE_VECTORS
configuration parameter). Current code assumes that the reset vector
location is always 0x0.

Add the XILINX_MICROBLAZE0_VECTOR_BASE_ADDR Kconfig option so the user
can adjust the reset vector address.

Signed-off-by: Ovidiu Panait <ovidiu.panait at windriver.com>
---

Changes in v2:
Added Kconfig option description.

 board/xilinx/microblaze-generic/Kconfig | 7 +++++++
 1 file changed, 7 insertions(+)

diff --git a/board/xilinx/microblaze-generic/Kconfig b/board/xilinx/microblaze-generic/Kconfig
index 3e3eca0e80..e31257d335 100644
--- a/board/xilinx/microblaze-generic/Kconfig
+++ b/board/xilinx/microblaze-generic/Kconfig
@@ -47,4 +47,11 @@ config XILINX_MICROBLAZE0_USR_EXCEP
 	  the exception vector table. The user exception vector is located at
 	  C_BASE_VECTORS + 0x8 address.
 
+config XILINX_MICROBLAZE0_VECTOR_BASE_ADDR
+	hex "Location of MicroBlaze vectors"
+	default 0x0
+	help
+	  Memory address location of the exception vector table. It is
+	  configurable via the C_BASE_VECTORS hdl parameter.
+
 endif
-- 
2.25.1