[PATCH v3 13/13] ARM: dts: stm32mp: dts: Don't remove OPTEE nodes for DK2 boards

[Alexandru Gagniuc]

To prepare for an OP-TEE payload, the spl_board_prepare_for_optee()
handler of STM32MP calls. stm32_init_tzc_for_optee(), which will
panic(). The reason for the panic is a failure to locate a valid
"/reserved-memory/optee" node in the devicetree.

This all occurs in SPL, so to re-add the OP-TEE memory nodes to the
SPL devicetree.

Signed-off-by: Alexandru Gagniuc <mr.nuke.me at gmail.com>
---
 arch/arm/dts/stm32mp157a-dk1-u-boot.dtsi | 3 ---
 1 file changed, 3 deletions(-)

diff --git a/arch/arm/dts/stm32mp157a-dk1-u-boot.dtsi b/arch/arm/dts/stm32mp157a-dk1-u-boot.dtsi
index fb60549f4d..fe347377ba 100644
--- a/arch/arm/dts/stm32mp157a-dk1-u-boot.dtsi
+++ b/arch/arm/dts/stm32mp157a-dk1-u-boot.dtsi
@@ -27,10 +27,7 @@
 	config {
 		u-boot,mmc-env-partition = "ssbl";
 	};
-#endif
 
-#ifdef CONFIG_STM32MP15x_STM32IMAGE
-	/* only needed for boot with TF-A, witout FIP support */
 	firmware {
 		optee {
 			compatible = "linaro,optee-tz";
-- 
2.31.1