[PATCH v3 1/2] spi: rockchip_sfc: Implement set_speed logic
Kever Yang
kever.yang at rock-chips.com
Sat Oct 9 17:04:37 CEST 2021
On 2021/9/17 下午9:14, Jon Lin wrote:
> Set clock related processing into set_speed logic. And Optimize
> printing format.
>
> Tested-by: Chris Morgan <macromorgan at hotmail.com>
> Signed-off-by: Jon Lin <jon.lin at rock-chips.com>
Reviewed-by: Kever Yang <kever.yang at rock-chips.com>
Thanks,
- Kever
> ---
>
> Changes in v3:
> - Remove useless headfile
> - Fix misspelling
>
> drivers/spi/rockchip_sfc.c | 82 ++++++++++++++++++--------------------
> 1 file changed, 39 insertions(+), 43 deletions(-)
>
> diff --git a/drivers/spi/rockchip_sfc.c b/drivers/spi/rockchip_sfc.c
> index 4e2b861f22..94222df5ce 100644
> --- a/drivers/spi/rockchip_sfc.c
> +++ b/drivers/spi/rockchip_sfc.c
> @@ -116,6 +116,7 @@
>
> /* Master trigger */
> #define SFC_DMA_TRIGGER 0x80
> +#define SFC_DMA_TRIGGER_START 1
>
> /* Src or Dst addr for master */
> #define SFC_DMA_ADDR 0x84
> @@ -163,14 +164,12 @@
> #define SFC_DMA_TRANS_THRETHOLD (0x40)
>
> /* Maximum clock values from datasheet suggest keeping clock value under
> - * 150MHz. No minimum or average value is suggested, but the U-boot BSP driver
> - * has a minimum of 10MHz and a default of 80MHz which seems reasonable.
> + * 150MHz. No minimum or average value is suggested.
> */
> -#define SFC_MIN_SPEED_HZ (10 * 1000 * 1000)
> -#define SFC_DEFAULT_SPEED_HZ (80 * 1000 * 1000)
> -#define SFC_MAX_SPEED_HZ (150 * 1000 * 1000)
> +#define SFC_MAX_SPEED (150 * 1000 * 1000)
>
> struct rockchip_sfc {
> + struct udevice *dev;
> void __iomem *regbase;
> struct clk hclk;
> struct clk clk;
> @@ -197,8 +196,6 @@ static int rockchip_sfc_reset(struct rockchip_sfc *sfc)
> /* Still need to clear the masked interrupt from RISR */
> writel(0xFFFFFFFF, sfc->regbase + SFC_ICLR);
>
> - debug("reset\n");
> -
> return err;
> }
>
> @@ -261,15 +258,11 @@ static int rockchip_sfc_probe(struct udevice *bus)
> #if CONFIG_IS_ENABLED(CLK)
> ret = clk_enable(&sfc->hclk);
> if (ret)
> - debug("Enable ahb clock fail %s: %d\n", bus->name, ret);
> + dev_dbg(sfc->dev, "sfc Enable ahb clock fail %s: %d\n", bus->name, ret);
>
> ret = clk_enable(&sfc->clk);
> if (ret)
> - debug("Enable clock fail for %s: %d\n", bus->name, ret);
> -
> - ret = clk_set_rate(&sfc->clk, SFC_DEFAULT_SPEED_HZ);
> - if (ret)
> - debug("Could not set sfc clock for %s: %d\n", bus->name, ret);
> + dev_dbg(sfc->dev, "sfc Enable clock fail for %s: %d\n", bus->name, ret);
> #endif
>
> ret = rockchip_sfc_init(sfc);
> @@ -278,7 +271,8 @@ static int rockchip_sfc_probe(struct udevice *bus)
>
> sfc->max_iosize = rockchip_sfc_get_max_iosize(sfc);
> sfc->version = rockchip_sfc_get_version(sfc);
> - sfc->speed = SFC_DEFAULT_SPEED_HZ;
> + sfc->max_freq = SFC_MAX_SPEED;
> + sfc->dev = bus;
>
> return 0;
>
> @@ -411,11 +405,11 @@ static int rockchip_sfc_xfer_setup(struct rockchip_sfc *sfc,
> ctrl |= SFC_CTRL_PHASE_SEL_NEGETIVE;
> cmd |= plat->cs << SFC_CMD_CS_SHIFT;
>
> - debug("addr.nbytes=%x(x%d) dummy.nbytes=%x(x%d)\n",
> - op->addr.nbytes, op->addr.buswidth,
> - op->dummy.nbytes, op->dummy.buswidth);
> - debug("ctrl=%x cmd=%x addr=%llx len=%x\n",
> - ctrl, cmd, op->addr.val, len);
> + dev_dbg(sfc->dev, "sfc addr.nbytes=%x(x%d) dummy.nbytes=%x(x%d)\n",
> + op->addr.nbytes, op->addr.buswidth,
> + op->dummy.nbytes, op->dummy.buswidth);
> + dev_dbg(sfc->dev, "sfc ctrl=%x cmd=%x addr=%llx len=%x\n",
> + ctrl, cmd, op->addr.val, len);
>
> writel(ctrl, sfc->regbase + SFC_CTRL);
> writel(cmd, sfc->regbase + SFC_CMD);
> @@ -492,7 +486,7 @@ static int rockchip_sfc_fifo_transfer_dma(struct rockchip_sfc *sfc, dma_addr_t d
> {
> writel(0xFFFFFFFF, sfc->regbase + SFC_ICLR);
> writel((u32)dma_buf, sfc->regbase + SFC_DMA_ADDR);
> - writel(0x1, sfc->regbase + SFC_DMA_TRIGGER);
> + writel(SFC_DMA_TRIGGER_START, sfc->regbase + SFC_DMA_TRIGGER);
>
> return len;
> }
> @@ -500,7 +494,7 @@ static int rockchip_sfc_fifo_transfer_dma(struct rockchip_sfc *sfc, dma_addr_t d
> static int rockchip_sfc_xfer_data_poll(struct rockchip_sfc *sfc,
> const struct spi_mem_op *op, u32 len)
> {
> - debug("xfer_poll len=%x\n", len);
> + dev_dbg(sfc->dev, "sfc xfer_poll len=%x\n", len);
>
> if (op->data.dir == SPI_MEM_DATA_OUT)
> return rockchip_sfc_write_fifo(sfc, op->data.buf.out, len);
> @@ -516,7 +510,7 @@ static int rockchip_sfc_xfer_data_dma(struct rockchip_sfc *sfc,
> void *dma_buf;
> int ret;
>
> - debug("xfer_dma len=%x\n", len);
> + dev_dbg(sfc->dev, "sfc xfer_dma len=%x\n", len);
>
> if (op->data.dir == SPI_MEM_DATA_OUT) {
> dma_buf = (void *)op->data.buf.out;
> @@ -564,33 +558,16 @@ static int rockchip_sfc_exec_op(struct spi_slave *mem,
> u32 len = min_t(u32, op->data.nbytes, sfc->max_iosize);
> int ret;
>
> -#if CONFIG_IS_ENABLED(CLK)
> - if (unlikely(mem->max_hz != sfc->speed)) {
> - ret = clk_set_rate(&sfc->clk, clamp(mem->max_hz, (uint)SFC_MIN_SPEED_HZ,
> - (uint)SFC_MAX_SPEED_HZ));
> - if (ret < 0) {
> - printf("set_freq=%dHz fail, check if it's the cru support level\n",
> - mem->max_hz);
> - return ret;
> - }
> -
> - sfc->max_freq = mem->max_hz;
> - sfc->speed = mem->max_hz;
> - debug("set_freq=%dHz real_freq=%dHz\n", sfc->max_freq, sfc->speed);
> - }
> -#endif
> -
> rockchip_sfc_adjust_op_work((struct spi_mem_op *)op);
> -
> rockchip_sfc_xfer_setup(sfc, mem, op, len);
> if (len) {
> - if (likely(sfc->use_dma) && !(len & 0x3) && len >= SFC_DMA_TRANS_THRETHOLD)
> + if (likely(sfc->use_dma) && len >= SFC_DMA_TRANS_THRETHOLD)
> ret = rockchip_sfc_xfer_data_dma(sfc, op, len);
> else
> ret = rockchip_sfc_xfer_data_poll(sfc, op, len);
>
> if (ret != len) {
> - printf("xfer data failed ret %d dir %d\n", ret, op->data.dir);
> + dev_err(sfc->dev, "xfer data failed ret %d dir %d\n", ret, op->data.dir);
>
> return -EIO;
> }
> @@ -604,13 +581,32 @@ static int rockchip_sfc_adjust_op_size(struct spi_slave *mem, struct spi_mem_op
> struct rockchip_sfc *sfc = dev_get_plat(mem->dev->parent);
>
> op->data.nbytes = min(op->data.nbytes, sfc->max_iosize);
> +
> return 0;
> }
>
> static int rockchip_sfc_set_speed(struct udevice *bus, uint speed)
> {
> - /* We set up speed later for each transmission.
> - */
> + struct rockchip_sfc *sfc = dev_get_plat(bus);
> +
> + if (speed > sfc->max_freq)
> + speed = sfc->max_freq;
> +
> + if (speed == sfc->speed)
> + return 0;
> +
> +#if CONFIG_IS_ENABLED(CLK)
> + int ret = clk_set_rate(&sfc->clk, speed);
> +
> + if (ret < 0) {
> + dev_err(sfc->dev, "set_freq=%dHz fail, check if it's the cru support level\n",
> + speed);
> + return ret;
> + }
> + sfc->speed = speed;
> +#else
> + dev_dbg(sfc->dev, "sfc failed, CLK not support\n");
> +#endif
> return 0;
> }
>
More information about the U-Boot
mailing list