[PATCH v4 2/4] cmd: Add ncsi command

[Joel Stanley]

From: Samuel Mendoza-Jonas <sam at mendozajonas.com>

Adds an "ncsi" command to manually start NC-SI configuration.

Signed-off-by: Samuel Mendoza-Jonas <sam at mendozajonas.com>
Signed-off-by: Joel Stanley <joel at jms.id.au>
---
v4: New patch, split from patch 1

 cmd/net.c   | 22 ++++++++++++++++++++++
 net/net.c   |  1 +
 cmd/Kconfig |  8 ++++++++
 3 files changed, 31 insertions(+)

diff --git a/cmd/net.c b/cmd/net.c
index 3619c843d838..2863fe768118 100644
--- a/cmd/net.c
+++ b/cmd/net.c
@@ -16,6 +16,7 @@
 #include <net.h>
 #include <net/udp.h>
 #include <net/sntp.h>
+#include <net/ncsi.h>
 
 static int netboot_common(enum proto_t, struct cmd_tbl *, int, char * const []);
 
@@ -524,3 +525,24 @@ U_BOOT_CMD(
 	"list - list available devices\n"
 );
 #endif // CONFIG_DM_ETH
+
+#if defined(CONFIG_CMD_NCSI)
+static int do_ncsi(struct cmd_tbl *cmdtp, int flag, int argc, char * const argv[])
+{
+	if (!phy_interface_is_ncsi() || !ncsi_active()) {
+		printf("Device not configured for NC-SI\n");
+		return CMD_RET_FAILURE;
+	}
+
+	if (net_loop(NCSI) < 0)
+		return CMD_RET_FAILURE;
+
+	return CMD_RET_SUCCESS;
+}
+
+U_BOOT_CMD(
+	ncsi,	1,	1,	do_ncsi,
+	"Configure attached NIC via NC-SI",
+	""
+);
+#endif  /* CONFIG_CMD_NCSI */
diff --git a/net/net.c b/net/net.c
index f0faf33d0d77..a4e645ac4425 100644
--- a/net/net.c
+++ b/net/net.c
@@ -434,6 +434,7 @@ int net_loop(enum proto_t protocol)
 	} else {
 		eth_init_state_only();
 	}
+
 restart:
 #ifdef CONFIG_USB_KEYBOARD
 	net_busy_flag = 0;
diff --git a/cmd/Kconfig b/cmd/Kconfig
index 3625ff2a50b3..3a5d1bba78a8 100644
--- a/cmd/Kconfig
+++ b/cmd/Kconfig
@@ -1813,6 +1813,14 @@ config CMD_LINK_LOCAL
 	help
 	  Acquire a network IP address using the link-local protocol
 
+config CMD_NCSI
+	bool "ncsi"
+	depends on PHY_NCSI
+	help
+	  Manually configure the attached NIC via NC-SI.
+	  Normally this happens automatically before other network
+	  operations.
+
 endif
 
 config CMD_ETHSW
-- 
2.35.1