[PATCH] fpga: zynq: Remove post config info message for SPL

[Stefan Herbrechtsmeier]

From: Stefan Herbrechtsmeier <stefan.herbrechtsmeier at weidmueller.com>

The drivers informs the user that a post config was not run after FPGA
configuration. This message is unnecessary in SPL because the
ps7_post_config function is called via spl_board_prepare_for_boot
function before jump_to_image_no_args function from board_init_r
function.

Signed-off-by: Stefan Herbrechtsmeier <stefan.herbrechtsmeier at weidmueller.com>

---

 drivers/fpga/zynqpl.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/drivers/fpga/zynqpl.c b/drivers/fpga/zynqpl.c
index d8ebd542ab..0c83df46da 100644
--- a/drivers/fpga/zynqpl.c
+++ b/drivers/fpga/zynqpl.c
@@ -413,7 +413,8 @@ static int zynq_load(xilinx_desc *desc, const void *buf, size_t bsize,
 	if (bstype != BIT_PARTIAL)
 		zynq_slcr_devcfg_enable();
 
-	puts("INFO:post config was not run, please run manually if needed\n");
+	if (!IS_ENABLED(CONFIG_SPL_BUILD))
+		puts("INFO:post config was not run, please run manually if needed\n");
 
 	return FPGA_SUCCESS;
 }
-- 
2.30.2