[RESEND PATCH 0/2] rpi: Copy eth PHY address from fw DT to loaded DT

[Antoine Mazeas]

I had not used patman in the first instance and Matthias Brugger was not cc’ed with the patch properly. Given that I had no feedback, I thought best to resubmit via patman this time in case it had not been seen the first time because of this.
However patman also picked up a different series title and did not allow for superseding the first submission. 

I hope this lapse in process does not reflect too badly on this patch.

Regards 

> Le 19 août 2022 à 16:15, Peter Robinson <pbrobinson at gmail.com> a écrit :
> Why did you need to resend it?
> 
> On Fri, Aug 19, 2022 at 3:08 PM Antoine Mazeas <antoine at karthanis.net> wrote:
>> 
>> Sjoerd Simons submitted the original patch (0001) to carry over some
>> firmware-provided properties into the loaded device tree. This did not fix
>> an issue with Raspberry Pi 400 rev 1.1 boards which would not be able to
>> find the ethernet PHY device at the address specified by the kernel device
>> tree.
>> 
>> Patch 0002 expands on Sjoerd's design to also carry over the real ethernet
>> PHY address, enabling the kernel to find and enable a working ethernet on
>> pi 400 rev 1.1 boards.
>> 
>> 
>> Antoine Mazeas (2):
>>  rpi: Copy properties from firmware dtb to the loaded dtb
>>  rpi: Copy eth PHY address from fw DT to loaded DT
>> 
>> board/raspberrypi/rpi/rpi.c | 51 +++++++++++++++++++++++++++++++++++++
>> 1 file changed, 51 insertions(+)
>> 
>> --
>> 2.37.2