[PATCH v3 2/4] rockchip: rk-3399: rock-pi-4: dts: Add XTX SPI NOR 4MiB Flash chip in Rock Pi 4 boards from rev 1.4 on.

Kever Yang kever.yang at rock-chips.com
Sat Aug 27 06:02:49 CEST 2022


On 2022/7/20 23:41, Xavier Drudis Ferran wrote:
> Configure Rock Pi 4 to boot from SPI NOR Flash.
>
> Based on flash chip, board documentation and tests, this is the
> fastest I could use it.
>
> This seems to be the minimum necessary configuration for Rock Pi 4 to
> be able to boot from SPI NOR Flash.
>
> With the next patch, it works to sf probe 1:0, sf read, sf erase, sf
> write, sf read and then boot linux and flashrom can write to
> it. Sometimes flashrom seems to fail to write when at U-Boot stage
> there was no sf read or write, not sure why. Might work better after
> a little while off power.
>
> Note: It seems to work with or without CONFIG_SPL_SPI_FLASH_TINY If I
>        disable it, and enable CONFIG_SPL_SPI_FLASH_SFDP_SUPPORT I have
>        to increase CONFIG_SPL_MAX_SIZE (I set it to 0x2e800) because
>        the SPL grew over 1200 bytes bigger. It might work better, or
>        just be chance, but it boots from SPI 0.3s slower. So I leave
>        this out of this patch.
>
> Changed since v2:
>
>      - added CONFIG_SPL_DM_SEQ_ALIAS to keep spi1 numeration consistent
>        between SPL and U-Boot
>
> Changed since v1:
>
>      - include CONFIG_SF_DEFAULT_BUS=1 now that numeration
>        will be unified between U-Boot and SPL (at patch 5/5)
>   
> Cc: Simon Glass <sjg at chromium.org>
> Cc: Philipp Tomsich <philipp.tomsich at vrull.eu>
> Cc: Kever Yang <kever.yang at rock-chips.com>
>
> Signed-off-by: Xavier Drudis Ferran <xdrudis at tinet.cat>

Reviewed-by: Kever Yang <kever.yang at rock-chips.com>

Thanks,
- Kever
> ---
>   arch/arm/dts/rk3399-rock-pi-4-u-boot.dtsi | 18 ++++++++++++++++++
>   configs/rock-pi-4-rk3399_defconfig        | 22 ++++++++++++++++++++++
>   2 files changed, 40 insertions(+)
>
> diff --git a/arch/arm/dts/rk3399-rock-pi-4-u-boot.dtsi b/arch/arm/dts/rk3399-rock-pi-4-u-boot.dtsi
> index c17e769f64..4c2fe8f6bc 100644
> --- a/arch/arm/dts/rk3399-rock-pi-4-u-boot.dtsi
> +++ b/arch/arm/dts/rk3399-rock-pi-4-u-boot.dtsi
> @@ -15,3 +15,21 @@
>   &vdd_log {
>   	regulator-init-microvolt = <950000>;
>   };
> +
> +&spi1 {
> +	status = "okay";
> +	spi-max-frequency = <40000000>;
> +	spi-activate-delay = <12000>; /* 12 ms */
> +
> +	norflash: flash at 0 {
> +		compatible = "rockchip,spidev", "jedec,spi-nor";
> +		reg = <0>;
> +
> +		spi-max-frequency = <40000000>;
> +		spi-cpha;
> +		spi-cpol;
> +
> +		status = "okay";
> +		u-boot,dm-pre-reloc;
> +	};
> +};
> diff --git a/configs/rock-pi-4-rk3399_defconfig b/configs/rock-pi-4-rk3399_defconfig
> index cf2e9fbde3..d5fadcb64f 100644
> --- a/configs/rock-pi-4-rk3399_defconfig
> +++ b/configs/rock-pi-4-rk3399_defconfig
> @@ -10,6 +10,8 @@ CONFIG_ROCKCHIP_RK3399=y
>   CONFIG_TARGET_EVB_RK3399=y
>   CONFIG_DEBUG_UART_BASE=0xFF1A0000
>   CONFIG_DEBUG_UART_CLOCK=24000000
> +CONFIG_SPL_SPI_FLASH_SUPPORT=y
> +CONFIG_SPL_SPI=y
>   CONFIG_SYS_LOAD_ADDR=0x800800
>   CONFIG_DEBUG_UART=y
>   CONFIG_HAS_CUSTOM_SYS_INIT_SP_ADDR=y
> @@ -28,6 +30,10 @@ CONFIG_SPL_BSS_MAX_SIZE=0x2000
>   CONFIG_SPL_STACK=0x400000
>   CONFIG_SPL_STACK_R=y
>   CONFIG_SPL_STACK_R_MALLOC_SIMPLE_LEN=0x10000
> +CONFIG_SPL_MTD_SUPPORT=y
> +CONFIG_SPL_SPI_FLASH_MTD=y
> +CONFIG_SPL_SPI_LOAD=y
> +CONFIG_SYS_SPI_U_BOOT_OFFS=0xb0000
>   CONFIG_TPL=y
>   CONFIG_CMD_BOOTZ=y
>   CONFIG_CMD_GPT=y
> @@ -40,6 +46,7 @@ CONFIG_SPL_OF_CONTROL=y
>   CONFIG_OF_SPL_REMOVE_PROPS="pinctrl-0 pinctrl-names clock-names interrupt-parent assigned-clocks assigned-clock-rates assigned-clock-parents"
>   CONFIG_ENV_IS_IN_MMC=y
>   CONFIG_SYS_RELOC_GD_ENV_ADDR=y
> +CONFIG_SPL_DM_SEQ_ALIAS=y
>   CONFIG_ROCKCHIP_GPIO=y
>   CONFIG_SYS_I2C_ROCKCHIP=y
>   CONFIG_MISC=y
> @@ -48,21 +55,36 @@ CONFIG_MMC_DW=y
>   CONFIG_MMC_DW_ROCKCHIP=y
>   CONFIG_MMC_SDHCI=y
>   CONFIG_MMC_SDHCI_ROCKCHIP=y
> +CONFIG_MTD=y
> +CONFIG_DM_MTD=y
> +CONFIG_SF_DEFAULT_BUS=1
> +CONFIG_SF_DEFAULT_MODE=0x3
> +CONFIG_SF_DEFAULT_SPEED=40000000
> +CONFIG_SPI_FLASH_SFDP_SUPPORT=y
> +CONFIG_SPI_FLASH_SOFT_RESET=y
> +CONFIG_SPI_FLASH_SOFT_RESET_ON_BOOT=y
> +CONFIG_SPI_FLASH_XTX=y
> +CONFIG_SPI_FLASH_MTD=y
>   CONFIG_DM_ETH=y
>   CONFIG_ETH_DESIGNWARE=y
>   CONFIG_GMAC_ROCKCHIP=y
>   CONFIG_NVME_PCI=y
>   CONFIG_PCI=y
> +CONFIG_SPL_PHY=y
>   CONFIG_PHY_ROCKCHIP_INNO_USB2=y
>   CONFIG_PHY_ROCKCHIP_TYPEC=y
> +CONFIG_DM_PMIC_FAN53555=y
>   CONFIG_PMIC_RK8XX=y
>   CONFIG_REGULATOR_PWM=y
> +CONFIG_SPL_REGULATOR_PWM=y
> +CONFIG_DM_REGULATOR_GPIO=y
>   CONFIG_REGULATOR_RK8XX=y
>   CONFIG_PWM_ROCKCHIP=y
>   CONFIG_RAM_RK3399_LPDDR4=y
>   CONFIG_DM_RESET=y
>   CONFIG_BAUDRATE=1500000
>   CONFIG_DEBUG_UART_SHIFT=2
> +CONFIG_ROCKCHIP_SPI=y
>   CONFIG_SYSRESET=y
>   CONFIG_USB=y
>   CONFIG_USB_XHCI_HCD=y


More information about the U-Boot mailing list