[PATCH 2/2] arm64: zynqmp: Enable TI phy reset via GPIO

[Michal Simek]

From: Harini Katakam <harini.katakam at amd.com>

Add DT property to support reset of TI PHY connected to GEM.
This is present in RevA DT but needs to be extended RevB/1.0/1.1
versions which are built on top.

Fixes: 2b1db7b18c97 ("arm64: zynqmp: Wire GEM reset gpio")
Signed-off-by: Harini Katakam <harini.katakam at amd.com>
Signed-off-by: Michal Simek <michal.simek at amd.com>
---

 arch/arm/dts/zynqmp-zcu102-revB.dts | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/arm/dts/zynqmp-zcu102-revB.dts b/arch/arm/dts/zynqmp-zcu102-revB.dts
index b2f0b1133175..de3b5ab9d93b 100644
--- a/arch/arm/dts/zynqmp-zcu102-revB.dts
+++ b/arch/arm/dts/zynqmp-zcu102-revB.dts
@@ -25,7 +25,7 @@
 			ti,tx-internal-delay = <0xa>;
 			ti,fifo-depth = <0x1>;
 			ti,dp83867-rxctrl-strap-quirk;
-			/* reset-gpios = <&tca6416_u97 6 GPIO_ACTIVE_LOW>; */
+			reset-gpios = <&tca6416_u97 6 GPIO_ACTIVE_LOW>;
 		};
 		/* Cleanup from RevA */
 		/delete-node/ ethernet-phy at 21;
-- 
2.36.1