[PATCH V2 06/12] oboard: ti: j721s2: Add support for detecting multiple device trees
Sinthu Raja
sinthu.raja at mistralsolutions.com
Wed Dec 21 14:52:13 CET 2022
From: Sinthu Raja <sinthu.raja at ti.com>
Update the board_fit_config_name_match() to choose the right dtb
based on the board name read from EEPROM.
Also restrict multpile EEPROM reads by verifying if EEPROM is already
read
Signed-off-by: Sinthu Raja <sinthu.raja at ti.com>
---
Address review comments:
- Remove support for detecting multiple device trees using different DTB
V1: https://patchwork.ozlabs.org/project/uboot/patch/20221027104846.11820-7-sinthu.raja@ti.com/
board/ti/j721s2/evm.c | 30 ++++++++++++++++++++----------
1 file changed, 20 insertions(+), 10 deletions(-)
diff --git a/board/ti/j721s2/evm.c b/board/ti/j721s2/evm.c
index 88470e4d71..7e448bd51c 100644
--- a/board/ti/j721s2/evm.c
+++ b/board/ti/j721s2/evm.c
@@ -72,16 +72,6 @@ int dram_init_banksize(void)
return 0;
}
-#ifdef CONFIG_SPL_LOAD_FIT
-int board_fit_config_name_match(const char *name)
-{
- if (!strcmp(name, "k3-j721s2-common-proc-board"))
- return 0;
-
- return -1;
-}
-#endif
-
#if defined(CONFIG_OF_LIBFDT) && defined(CONFIG_OF_BOARD_SETUP)
int ft_board_setup(void *blob, struct bd_info *bd)
{
@@ -111,6 +101,9 @@ int do_board_detect(void)
{
int ret;
+ if (board_ti_was_eeprom_read())
+ return 0;
+
ret = ti_i2c_eeprom_am6_get_base(CONFIG_EEPROM_BUS_ADDRESS,
CONFIG_EEPROM_CHIP_ADDRESS);
if (ret) {
@@ -179,6 +172,23 @@ static void setup_serial(void)
}
#endif
+#ifdef CONFIG_SPL_LOAD_FIT
+int board_fit_config_name_match(const char *name)
+{
+ bool eeprom_read = board_ti_was_eeprom_read();
+
+ if (!eeprom_read || board_is_j721s2_som()) {
+ if (!strcmp(name, "k3-j721s2-common-proc-board"))
+ return 0;
+ } else if (!eeprom_read || board_is_am68_sk_som()) {
+ if (!strcmp(name, "k3-am68-sk-base-board"))
+ return 0;
+ }
+
+ return -1;
+}
+#endif
+
int board_late_init(void)
{
if (IS_ENABLED(CONFIG_TI_I2C_BOARD_DETECT)) {
--
2.36.1
More information about the U-Boot
mailing list