[PATCH v2 10/23] mips: Move endianness selection to arch/Kconfig

[Michal Simek]

This option will be used by Microblaze that's why move it to generic
location to be able to use it.

Signed-off-by: Michal Simek <michal.simek at amd.com>
---

Changes in v2:
- new patch in series to solve Kconfig warning

 arch/Kconfig      | 22 ++++++++++++++++++++++
 arch/mips/Kconfig | 18 ------------------
 2 files changed, 22 insertions(+), 18 deletions(-)

diff --git a/arch/Kconfig b/arch/Kconfig
index 12de8a11650d..4851300e9bbe 100644
--- a/arch/Kconfig
+++ b/arch/Kconfig
@@ -447,3 +447,25 @@ source "arch/xtensa/Kconfig"
 source "arch/riscv/Kconfig"
 
 source "board/keymile/Kconfig"
+
+if MIPS
+
+choice
+	prompt "Endianness selection"
+	help
+	  Some MIPS boards can be configured for either little or big endian
+	  byte order. These modes require different U-Boot images. In general there
+	  is one preferred byteorder for a particular system but some systems are
+	  just as commonly used in the one or the other endianness.
+
+config SYS_BIG_ENDIAN
+	bool "Big endian"
+	depends on SUPPORTS_BIG_ENDIAN
+
+config SYS_LITTLE_ENDIAN
+	bool "Little endian"
+	depends on SUPPORTS_LITTLE_ENDIAN
+
+endchoice
+
+endif
diff --git a/arch/mips/Kconfig b/arch/mips/Kconfig
index 9b62764f4fe6..2e0793a7a7b8 100644
--- a/arch/mips/Kconfig
+++ b/arch/mips/Kconfig
@@ -180,24 +180,6 @@ source "arch/mips/mach-octeon/Kconfig"
 
 if MIPS
 
-choice
-	prompt "Endianness selection"
-	help
-	  Some MIPS boards can be configured for either little or big endian
-	  byte order. These modes require different U-Boot images. In general there
-	  is one preferred byteorder for a particular system but some systems are
-	  just as commonly used in the one or the other endianness.
-
-config SYS_BIG_ENDIAN
-	bool "Big endian"
-	depends on SUPPORTS_BIG_ENDIAN
-
-config SYS_LITTLE_ENDIAN
-	bool "Little endian"
-	depends on SUPPORTS_LITTLE_ENDIAN
-
-endchoice
-
 choice
 	prompt "CPU selection"
 	default CPU_MIPS32_R2
-- 
2.36.0