[RFC] Create arch/Kconfig.nxp

[Stefano Babic]

On 15.06.22 20:00, Tom Rini wrote:
> Hey all,
> 
> As I migrate assorted CONFIG options over to Kconfig, a common problem I
> run in to is that between m68k, PowerPC and ARM (both Layerscape and
> sometimes i.MX) there are options that fit under more than one
> architecture but also don't have a good place to go.  For example, I
> just ran in to CONFIG_SYS_FSL_NUM_CC_PLLS which started as PowerPC
> specific, but is used still in Layerscape and more of a SoC detail (but
> wouldn't make sense in drivers/soc/Kconfig).

That's right, there is IP in common that can be factorized.

>  I was thinking that
> perhaps arch/Kconfig.nxp would be a good starting place to put these
> options, but I'm quite open to other suggestions.

+1

It looks to me a good idea ;-)

Regards,
Stefano


-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, 82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================