[PoC 058/241] global: Migrate CONFIG_I2C_MULTI_BUS to CFG
Tom Rini
trini at konsulko.com
Sun Nov 20 14:30:49 CET 2022
Signed-off-by: Tom Rini <trini at konsulko.com>
---
README | 8 ++++----
cmd/i2c.c | 12 ++++++------
drivers/i2c/mv_i2c.c | 4 ++--
include/configs/display5.h | 2 +-
include/configs/km/pg-wcom-ls102xa.h | 2 +-
include/configs/novena.h | 2 +-
include/configs/omap3_beagle.h | 2 +-
include/configs/sniper.h | 2 +-
include/configs/tqma6.h | 2 +-
include/i2c.h | 2 +-
scripts/config_whitelist.txt | 2 +-
11 files changed, 20 insertions(+), 20 deletions(-)
diff --git a/README b/README
index d76058e1ab41..50bfd7e4fffc 100644
--- a/README
+++ b/README
@@ -1006,7 +1006,7 @@ The following options need to be configured:
You should define these to the GPIO value as given directly to
the generic GPIO functions.
- CONFIG_I2C_MULTI_BUS
+ CFG_I2C_MULTI_BUS
This option allows the use of multiple I2C buses, each of which
must have a controller. At any point in time, only one bus is
@@ -1016,17 +1016,17 @@ The following options need to be configured:
CFG_SYS_I2C_NOPROBES
This option specifies a list of I2C devices that will be skipped
- when the 'i2c probe' command is issued. If CONFIG_I2C_MULTI_BUS
+ when the 'i2c probe' command is issued. If CFG_I2C_MULTI_BUS
is set, specify a list of bus-device pairs. Otherwise, specify
a 1D array of device addresses
e.g.
- #undef CONFIG_I2C_MULTI_BUS
+ #undef CFG_I2C_MULTI_BUS
#define CFG_SYS_I2C_NOPROBES {0x50,0x68}
will skip addresses 0x50 and 0x68 on a board with one I2C bus
- #define CONFIG_I2C_MULTI_BUS
+ #define CFG_I2C_MULTI_BUS
#define CFG_SYS_I2C_NOPROBES {{0,0x50},{0,0x68},{1,0x54}}
will skip addresses 0x50 and 0x68 on bus 0 and address 0x54 on bus 1
diff --git a/cmd/i2c.c b/cmd/i2c.c
index da8b4c255555..2f9acc6670a3 100644
--- a/cmd/i2c.c
+++ b/cmd/i2c.c
@@ -98,7 +98,7 @@ static uint i2c_mm_last_alen;
* pairs. The following macros take care of this */
#if defined(CFG_SYS_I2C_NOPROBES)
-#if CONFIG_IS_ENABLED(SYS_I2C_LEGACY) || defined(CONFIG_I2C_MULTI_BUS)
+#if CONFIG_IS_ENABLED(SYS_I2C_LEGACY) || defined(CFG_I2C_MULTI_BUS)
static struct
{
uchar bus;
@@ -1764,7 +1764,7 @@ static int do_i2c_show_bus(struct cmd_tbl *cmdtp, int flag, int argc,
* Returns zero on success, CMD_RET_USAGE in case of misuse and negative
* on error.
*/
-#if CONFIG_IS_ENABLED(SYS_I2C_LEGACY) || defined(CONFIG_I2C_MULTI_BUS) || \
+#if CONFIG_IS_ENABLED(SYS_I2C_LEGACY) || defined(CFG_I2C_MULTI_BUS) || \
CONFIG_IS_ENABLED(DM_I2C)
static int do_i2c_bus_num(struct cmd_tbl *cmdtp, int flag, int argc,
char *const argv[])
@@ -1916,9 +1916,9 @@ static struct cmd_tbl cmd_i2c_sub[] = {
#endif
U_BOOT_CMD_MKENT(crc32, 3, 1, do_i2c_crc, "", ""),
#if CONFIG_IS_ENABLED(SYS_I2C_LEGACY) || \
- defined(CONFIG_I2C_MULTI_BUS) || CONFIG_IS_ENABLED(DM_I2C)
+ defined(CFG_I2C_MULTI_BUS) || CONFIG_IS_ENABLED(DM_I2C)
U_BOOT_CMD_MKENT(dev, 1, 1, do_i2c_bus_num, "", ""),
-#endif /* CONFIG_I2C_MULTI_BUS */
+#endif /* CFG_I2C_MULTI_BUS */
#if defined(CONFIG_I2C_EDID)
U_BOOT_CMD_MKENT(edid, 1, 1, do_edid, "", ""),
#endif /* CONFIG_I2C_EDID */
@@ -1993,9 +1993,9 @@ static char i2c_help_text[] =
#endif
"crc32 chip address[.0, .1, .2] count - compute CRC32 checksum\n"
#if CONFIG_IS_ENABLED(SYS_I2C_LEGACY) || \
- defined(CONFIG_I2C_MULTI_BUS) || CONFIG_IS_ENABLED(DM_I2C)
+ defined(CFG_I2C_MULTI_BUS) || CONFIG_IS_ENABLED(DM_I2C)
"i2c dev [dev] - show or set current I2C bus\n"
-#endif /* CONFIG_I2C_MULTI_BUS */
+#endif /* CFG_I2C_MULTI_BUS */
#if defined(CONFIG_I2C_EDID)
"i2c edid chip - print EDID configuration information\n"
#endif /* CONFIG_I2C_EDID */
diff --git a/drivers/i2c/mv_i2c.c b/drivers/i2c/mv_i2c.c
index 8ee17f0a4501..dffd551f2c29 100644
--- a/drivers/i2c/mv_i2c.c
+++ b/drivers/i2c/mv_i2c.c
@@ -374,7 +374,7 @@ static int __i2c_write(struct mv_i2c *base, uchar chip, u8 *addr, int alen,
static struct mv_i2c *base_glob;
-#ifdef CONFIG_I2C_MULTI_BUS
+#ifdef CFG_I2C_MULTI_BUS
static unsigned long i2c_regs[CONFIG_MV_I2C_NUM] = CONFIG_MV_I2C_REG;
static unsigned int bus_initialized[CONFIG_MV_I2C_NUM];
static unsigned int current_bus;
@@ -407,7 +407,7 @@ void i2c_init(int speed, int slaveaddr)
{
u32 val;
-#ifdef CONFIG_I2C_MULTI_BUS
+#ifdef CFG_I2C_MULTI_BUS
current_bus = 0;
base_glob = (struct mv_i2c *)i2c_regs[current_bus];
#else
diff --git a/include/configs/display5.h b/include/configs/display5.h
index f95c1602e676..191c8fb8ab46 100644
--- a/include/configs/display5.h
+++ b/include/configs/display5.h
@@ -37,7 +37,7 @@
#define CONFIG_MXC_UART_BASE UART5_BASE
/* I2C Configs */
-#define CONFIG_I2C_MULTI_BUS
+#define CFG_I2C_MULTI_BUS
/* MMC Configs */
#define CFG_SYS_FSL_ESDHC_ADDR 0
diff --git a/include/configs/km/pg-wcom-ls102xa.h b/include/configs/km/pg-wcom-ls102xa.h
index 80027f3a773a..e64cf24bd5e9 100644
--- a/include/configs/km/pg-wcom-ls102xa.h
+++ b/include/configs/km/pg-wcom-ls102xa.h
@@ -154,7 +154,7 @@
* I2C
*/
-#define CONFIG_I2C_MULTI_BUS
+#define CFG_I2C_MULTI_BUS
#define CFG_SYS_I2C_MAX_HOPS 1
#define CFG_SYS_NUM_I2C_BUSES 3
#define I2C_MUX_PCA_ADDR 0x70
diff --git a/include/configs/novena.h b/include/configs/novena.h
index 520c4ba130f1..af99ba4f193c 100644
--- a/include/configs/novena.h
+++ b/include/configs/novena.h
@@ -35,7 +35,7 @@
#define CFG_SYS_INIT_RAM_SIZE IRAM_SIZE
/* I2C */
-#define CONFIG_I2C_MULTI_BUS
+#define CFG_I2C_MULTI_BUS
/* I2C EEPROM */
diff --git a/include/configs/omap3_beagle.h b/include/configs/omap3_beagle.h
index efeb7bf10078..af7cb3513f8f 100644
--- a/include/configs/omap3_beagle.h
+++ b/include/configs/omap3_beagle.h
@@ -29,7 +29,7 @@
#endif /* CONFIG_MTD_RAW_NAND */
/* Enable Multi Bus support for I2C */
-#define CONFIG_I2C_MULTI_BUS
+#define CFG_I2C_MULTI_BUS
/* DSS Support */
diff --git a/include/configs/sniper.h b/include/configs/sniper.h
index eaee8dd37396..45a3102aeeef 100644
--- a/include/configs/sniper.h
+++ b/include/configs/sniper.h
@@ -38,7 +38,7 @@
* I2C
*/
-#define CONFIG_I2C_MULTI_BUS
+#define CFG_I2C_MULTI_BUS
/*
* Input
diff --git a/include/configs/tqma6.h b/include/configs/tqma6.h
index 14d7730f67bf..cb5f7fc25af9 100644
--- a/include/configs/tqma6.h
+++ b/include/configs/tqma6.h
@@ -28,7 +28,7 @@
#define TQMA6_SPI_FLASH_SECTOR_SIZE SZ_64K
/* I2C Configs */
-#define CONFIG_I2C_MULTI_BUS
+#define CFG_I2C_MULTI_BUS
#if !defined(CONFIG_DM_PMIC)
#define CONFIG_POWER_PFUZE100_I2C_ADDR 0x08
diff --git a/include/i2c.h b/include/i2c.h
index 51390f8fd84f..3811b26c08e0 100644
--- a/include/i2c.h
+++ b/include/i2c.h
@@ -930,7 +930,7 @@ unsigned int i2c_get_bus_speed(void);
* only for backwardcompatibility, should go away if we switched
* completely to new multibus support.
*/
-#if CONFIG_IS_ENABLED(SYS_I2C_LEGACY) || defined(CONFIG_I2C_MULTI_BUS)
+#if CONFIG_IS_ENABLED(SYS_I2C_LEGACY) || defined(CFG_I2C_MULTI_BUS)
# if !defined(CFG_SYS_MAX_I2C_BUS)
# define CFG_SYS_MAX_I2C_BUS 2
# endif
diff --git a/scripts/config_whitelist.txt b/scripts/config_whitelist.txt
index 440bef90575d..501e39bb4900 100644
--- a/scripts/config_whitelist.txt
+++ b/scripts/config_whitelist.txt
@@ -58,7 +58,7 @@ CFG_HOSTNAME
CFG_HSMMC2_8BIT
CFG_HW_ENV_SETTINGS
CFG_I2C_ENV_EEPROM_BUS
-CONFIG_I2C_MULTI_BUS
+CFG_I2C_MULTI_BUS
CONFIG_I2C_MVTWSI
CONFIG_I2C_MVTWSI_BASE0
CONFIG_I2C_MVTWSI_BASE1
--
2.25.1
More information about the U-Boot
mailing list