[PATCH V3 1/2] spi: cadence_qspi: setup ADDR Bits in cmd reads

Dhruva Gole d-gole at ti.com
Fri Nov 25 06:59:31 CET 2022


Setup the Addr bit field while issuing register reads in STIG mode. This
is needed for example flashes like cypress define in their transaction
table that to read any register there is 1 cmd byte and a few more address
bytes trailing the cmd byte. Absence of addr bytes will obviously fail
to read correct data from flash register that maybe requested by flash
driver because the controller doesn't even specify which address of the
flash register the read is being requested from.

Signed-off-by: Dhruva Gole <d-gole at ti.com>
---
 drivers/spi/cadence_qspi_apb.c | 13 +++++++++++++
 1 file changed, 13 insertions(+)

diff --git a/drivers/spi/cadence_qspi_apb.c b/drivers/spi/cadence_qspi_apb.c
index cfae5dcbda0e..45c1333e2d13 100644
--- a/drivers/spi/cadence_qspi_apb.c
+++ b/drivers/spi/cadence_qspi_apb.c
@@ -479,6 +479,19 @@ int cadence_qspi_apb_command_read(struct cadence_spi_priv *priv,
 	/* 0 means 1 byte. */
 	reg |= (((rxlen - 1) & CQSPI_REG_CMDCTRL_RD_BYTES_MASK)
 		<< CQSPI_REG_CMDCTRL_RD_BYTES_LSB);
+
+	/* setup ADDR BIT field */
+	if (op->addr.nbytes) {
+		writel(op->addr.val, priv->regbase + CQSPI_REG_CMDADDRESS);
+		/*
+		 * address bytes are zero indexed
+		 */
+		reg |= (((op->addr.nbytes - 1) &
+			  CQSPI_REG_CMDCTRL_ADD_BYTES_MASK) <<
+			  CQSPI_REG_CMDCTRL_ADD_BYTES_LSB);
+		reg |= (0x1 << CQSPI_REG_CMDCTRL_ADDR_EN_LSB);
+	}
+
 	status = cadence_qspi_apb_exec_flash_cmd(reg_base, reg);
 	if (status != 0)
 		return status;
-- 
2.25.1



More information about the U-Boot mailing list