[PATCH 1/3] arm: layerscape: Don't select FSL_IFC when booting from SD card

[Peng Fan]

On 10/12/2022 5:51 AM, Sean Anderson wrote:
> FSL_IFC should only be selected when booting from NAND flash (or when
> NAND_FSL_IFC is enabled). The existing logic does this correctly when
> QSPI is also enabled, but not when just booting from SD.
> 
> Signed-off-by: Sean Anderson <sean.anderson at seco.com>

Reviewed-by: Peng Fan <peng.fan at nxp.com>

> ---
> 
>   arch/arm/cpu/armv8/fsl-layerscape/Kconfig | 4 ++--
>   1 file changed, 2 insertions(+), 2 deletions(-)
> 
> diff --git a/arch/arm/cpu/armv8/fsl-layerscape/Kconfig b/arch/arm/cpu/armv8/fsl-layerscape/Kconfig
> index 80a1642447d..10eef84f8d9 100644
> --- a/arch/arm/cpu/armv8/fsl-layerscape/Kconfig
> +++ b/arch/arm/cpu/armv8/fsl-layerscape/Kconfig
> @@ -62,7 +62,7 @@ config ARCH_LS1043A
>   	bool
>   	select ARMV8_SET_SMPEN
>   	select ARM_ERRATA_855873 if !TFABOOT
> -	select FSL_IFC if TFABOOT || (!QSPI_BOOT && !SD_BOOT_QSPI)
> +	select FSL_IFC if TFABOOT || (!QSPI_BOOT && !SD_BOOT_QSPI || !SD_BOOT)
>   	select FSL_LAYERSCAPE
>   	select FSL_LSCH2
>   	select GICV2
> @@ -98,7 +98,7 @@ config ARCH_LS1043A
>   config ARCH_LS1046A
>   	bool
>   	select ARMV8_SET_SMPEN
> -	select FSL_IFC if TFABOOT || (!QSPI_BOOT && !SD_BOOT_QSPI)
> +	select FSL_IFC if TFABOOT || (!QSPI_BOOT && !SD_BOOT_QSPI && !SD_BOOT)
>   	select FSL_LAYERSCAPE
>   	select FSL_LSCH2
>   	select GICV2