[PATCH 5/7] fpga: spartan2: Use logging feature instead of FPGA_DEBUG
Alexander Dahl
ada at thorsis.com
Mon Sep 19 12:39:10 CEST 2022
Instead of using DEBUG or LOG_DEBUG the driver still had its own
definition for debug output.
Signed-off-by: Alexander Dahl <ada at thorsis.com>
---
drivers/fpga/spartan2.c | 34 +++++++++++++++-------------------
1 file changed, 15 insertions(+), 19 deletions(-)
diff --git a/drivers/fpga/spartan2.c b/drivers/fpga/spartan2.c
index 47692e3207..231a2e9e20 100644
--- a/drivers/fpga/spartan2.c
+++ b/drivers/fpga/spartan2.c
@@ -4,16 +4,12 @@
* Rich Ireland, Enterasys Networks, rireland at enterasys.com.
*/
+#define LOG_CATEGORY UCLASS_FS_FIRMWARE_LOADER
+
#include <common.h> /* core U-Boot definitions */
+#include <log.h>
#include <spartan2.h> /* Spartan-II device family */
-/* Define FPGA_DEBUG to get debug printf's */
-#ifdef FPGA_DEBUG
-#define PRINTF(fmt,args...) printf (fmt ,##args)
-#else
-#define PRINTF(fmt,args...)
-#endif
-
#undef CONFIG_SYS_FPGA_CHECK_BUSY
/* Note: The assumption is that we cannot possibly run fast enough to
@@ -46,12 +42,12 @@ static int spartan2_load(xilinx_desc *desc, const void *buf, size_t bsize,
switch (desc->iface) {
case slave_serial:
- PRINTF ("%s: Launching Slave Serial Load\n", __FUNCTION__);
+ log_debug("%s: Launching Slave Serial Load\n", __func__);
ret_val = spartan2_ss_load(desc, buf, bsize);
break;
case slave_parallel:
- PRINTF ("%s: Launching Slave Parallel Load\n", __FUNCTION__);
+ log_debug("%s: Launching Slave Parallel Load\n", __func__);
ret_val = spartan2_sp_load(desc, buf, bsize);
break;
@@ -69,12 +65,12 @@ static int spartan2_dump(xilinx_desc *desc, const void *buf, size_t bsize)
switch (desc->iface) {
case slave_serial:
- PRINTF ("%s: Launching Slave Serial Dump\n", __FUNCTION__);
+ log_debug("%s: Launching Slave Serial Dump\n", __func__);
ret_val = spartan2_ss_dump(desc, buf, bsize);
break;
case slave_parallel:
- PRINTF ("%s: Launching Slave Parallel Dump\n", __FUNCTION__);
+ log_debug("%s: Launching Slave Parallel Dump\n", __func__);
ret_val = spartan2_sp_dump(desc, buf, bsize);
break;
@@ -100,8 +96,8 @@ static int spartan2_sp_load(xilinx_desc *desc, const void *buf, size_t bsize)
int ret_val = FPGA_FAIL; /* assume the worst */
xilinx_spartan2_slave_parallel_fns *fn = desc->iface_fns;
- PRINTF ("%s: start with interface functions @ 0x%p\n",
- __FUNCTION__, fn);
+ log_debug("%s: start with interface functions @ 0x%p\n",
+ __func__, fn);
if (fn) {
size_t bytecount = 0;
@@ -109,7 +105,7 @@ static int spartan2_sp_load(xilinx_desc *desc, const void *buf, size_t bsize)
int cookie = desc->cookie; /* make a local copy */
unsigned long ts; /* timestamp */
- PRINTF ("%s: Function Table:\n"
+ log_debug("%s: Function Table:\n"
"ptr:\t0x%p\n"
"struct: 0x%p\n"
"pre: 0x%p\n"
@@ -124,7 +120,7 @@ static int spartan2_sp_load(xilinx_desc *desc, const void *buf, size_t bsize)
"busy:\t0x%p\n"
"abort:\t0x%p\n",
"post:\t0x%p\n\n",
- __FUNCTION__, &fn, fn, fn->pre, fn->pgm, fn->init, fn->err,
+ __func__, &fn, fn, fn->pre, fn->pgm, fn->init, fn->err,
fn->clk, fn->cs, fn->wr, fn->rdata, fn->wdata, fn->busy,
fn->abort, fn->post);
@@ -302,8 +298,8 @@ static int spartan2_ss_load(xilinx_desc *desc, const void *buf, size_t bsize)
int i;
unsigned char val;
- PRINTF ("%s: start with interface functions @ 0x%p\n",
- __FUNCTION__, fn);
+ log_debug("%s: start with interface functions @ 0x%p\n",
+ __func__, fn);
if (fn) {
size_t bytecount = 0;
@@ -311,7 +307,7 @@ static int spartan2_ss_load(xilinx_desc *desc, const void *buf, size_t bsize)
int cookie = desc->cookie; /* make a local copy */
unsigned long ts; /* timestamp */
- PRINTF ("%s: Function Table:\n"
+ log_debug("%s: Function Table:\n"
"ptr:\t0x%p\n"
"struct: 0x%p\n"
"pgm:\t0x%p\n"
@@ -319,7 +315,7 @@ static int spartan2_ss_load(xilinx_desc *desc, const void *buf, size_t bsize)
"clk:\t0x%p\n"
"wr:\t0x%p\n"
"done:\t0x%p\n\n",
- __FUNCTION__, &fn, fn, fn->pgm, fn->init,
+ __func__, &fn, fn, fn->pgm, fn->init,
fn->clk, fn->wr, fn->done);
#ifdef CONFIG_SYS_FPGA_PROG_FEEDBACK
printf ("Loading FPGA Device %d...\n", cookie);
--
2.30.2
More information about the U-Boot
mailing list