[PATCH v2 1/3] net: mvpp2: Drop PHY_INTERFACE_MODE_SGMII_2500 support
Ramon Fried
rfried.dev at gmail.com
Sat Apr 1 20:58:00 CEST 2023
On Tue, Mar 21, 2023 at 7:26 PM Marek Vasut
<marek.vasut+renesas at mailbox.org> wrote:
>
> This mode does not seem to be well defined and used anywhere, remove support for it.
> Based on discussion:
> - 1000baseX does c37 AN of duplex+pause
> - SGMII does AN of duplex+pause+speed, at lower speed bytes are repeated 10x/100x
> - 2500baseX does not do AN, or does very different c73 AN
> - SGMII 2500 behavior is unclear
>
> Signed-off-by: Marek Vasut <marek.vasut+renesas at mailbox.org>
> ---
> Cc: "Ariel D'Alessandro" <ariel.dalessandro at collabora.com>
> Cc: "Marek Behún" <kabel at kernel.org>
> Cc: Joe Hershberger <joe.hershberger at ni.com>
> Cc: Marek Vasut <marek.vasut+renesas at mailbox.org>
> Cc: Ramon Fried <rfried.dev at gmail.com>
> Cc: Stefan Roese <sr at denx.de>
> Cc: Tim Harvey <tharvey at gateworks.com>
> Cc: Vladimir Oltean <vladimir.oltean at nxp.com>
> ---
> V2: Drop SGMII 2500 support, if it becomes required and/or standardized,
> this patch can be reverted
> ---
> drivers/net/mvpp2.c | 53 ---------------------------------------------
> 1 file changed, 53 deletions(-)
>
> diff --git a/drivers/net/mvpp2.c b/drivers/net/mvpp2.c
> index 1bad50d344c..c99d52c85d7 100644
> --- a/drivers/net/mvpp2.c
> +++ b/drivers/net/mvpp2.c
> @@ -2871,7 +2871,6 @@ static void mvpp2_port_mii_set(struct mvpp2_port *port)
>
> switch (port->phy_interface) {
> case PHY_INTERFACE_MODE_SGMII:
> - case PHY_INTERFACE_MODE_SGMII_2500:
> val |= MVPP2_GMAC_INBAND_AN_MASK;
> break;
> case PHY_INTERFACE_MODE_1000BASEX:
> @@ -2939,7 +2938,6 @@ static void mvpp2_port_loopback_set(struct mvpp2_port *port)
> val &= ~MVPP2_GMAC_GMII_LB_EN_MASK;
>
> if (port->phy_interface == PHY_INTERFACE_MODE_SGMII ||
> - port->phy_interface == PHY_INTERFACE_MODE_SGMII_2500 ||
> port->phy_interface == PHY_INTERFACE_MODE_1000BASEX ||
> port->phy_interface == PHY_INTERFACE_MODE_2500BASEX)
> val |= MVPP2_GMAC_PCS_LB_EN_MASK;
> @@ -3027,48 +3025,6 @@ static int gop_bypass_clk_cfg(struct mvpp2_port *port, int en)
> return 0;
> }
>
> -static void gop_gmac_sgmii2_5_cfg(struct mvpp2_port *port)
> -{
> - u32 val, thresh;
> -
> - /*
> - * Configure minimal level of the Tx FIFO before the lower part
> - * starts to read a packet
> - */
> - thresh = MVPP2_SGMII2_5_TX_FIFO_MIN_TH;
> - val = readl(port->base + MVPP2_GMAC_PORT_FIFO_CFG_1_REG);
> - val &= ~MVPP2_GMAC_TX_FIFO_MIN_TH_ALL_MASK;
> - val |= MVPP2_GMAC_TX_FIFO_MIN_TH_MASK(thresh);
> - writel(val, port->base + MVPP2_GMAC_PORT_FIFO_CFG_1_REG);
> -
> - /* Disable bypass of sync module */
> - val = readl(port->base + MVPP2_GMAC_CTRL_4_REG);
> - val |= MVPP2_GMAC_CTRL4_SYNC_BYPASS_MASK;
> - /* configure DP clock select according to mode */
> - val |= MVPP2_GMAC_CTRL4_DP_CLK_SEL_MASK;
> - /* configure QSGMII bypass according to mode */
> - val |= MVPP2_GMAC_CTRL4_QSGMII_BYPASS_ACTIVE_MASK;
> - writel(val, port->base + MVPP2_GMAC_CTRL_4_REG);
> -
> - val = readl(port->base + MVPP2_GMAC_CTRL_0_REG);
> - /*
> - * Configure GIG MAC to SGMII mode connected to a fiber
> - * transceiver
> - */
> - val &= ~MVPP2_GMAC_PORT_TYPE_MASK;
> - writel(val, port->base + MVPP2_GMAC_CTRL_0_REG);
> -
> - /* configure AN 0x9268 */
> - val = MVPP2_GMAC_EN_PCS_AN |
> - MVPP2_GMAC_AN_BYPASS_EN |
> - MVPP2_GMAC_CONFIG_MII_SPEED |
> - MVPP2_GMAC_CONFIG_GMII_SPEED |
> - MVPP2_GMAC_FC_ADV_EN |
> - MVPP2_GMAC_CONFIG_FULL_DUPLEX |
> - MVPP2_GMAC_CHOOSE_SAMPLE_TX_CONFIG;
> - writel(val, port->base + MVPP2_GMAC_AUTONEG_CONFIG);
> -}
> -
> static void gop_gmac_sgmii_cfg(struct mvpp2_port *port)
> {
> u32 val, thresh;
> @@ -3239,9 +3195,6 @@ static int gop_gmac_mode_cfg(struct mvpp2_port *port)
> case PHY_INTERFACE_MODE_SGMII:
> gop_gmac_sgmii_cfg(port);
> break;
> - case PHY_INTERFACE_MODE_SGMII_2500:
> - gop_gmac_sgmii2_5_cfg(port);
> - break;
> case PHY_INTERFACE_MODE_1000BASEX:
> gop_gmac_1000basex_cfg(port);
> break;
> @@ -3422,7 +3375,6 @@ static int gop_port_init(struct mvpp2_port *port)
> break;
>
> case PHY_INTERFACE_MODE_SGMII:
> - case PHY_INTERFACE_MODE_SGMII_2500:
> case PHY_INTERFACE_MODE_1000BASEX:
> case PHY_INTERFACE_MODE_2500BASEX:
> /* configure PCS */
> @@ -3482,7 +3434,6 @@ static void gop_port_enable(struct mvpp2_port *port, int enable)
> case PHY_INTERFACE_MODE_RGMII:
> case PHY_INTERFACE_MODE_RGMII_ID:
> case PHY_INTERFACE_MODE_SGMII:
> - case PHY_INTERFACE_MODE_SGMII_2500:
> case PHY_INTERFACE_MODE_1000BASEX:
> case PHY_INTERFACE_MODE_2500BASEX:
> if (enable)
> @@ -3519,7 +3470,6 @@ static u32 mvpp2_netc_cfg_create(int gop_id, phy_interface_t phy_type)
>
> if (gop_id == 2) {
> if (phy_type == PHY_INTERFACE_MODE_SGMII ||
> - phy_type == PHY_INTERFACE_MODE_SGMII_2500 ||
> phy_type == PHY_INTERFACE_MODE_1000BASEX ||
> phy_type == PHY_INTERFACE_MODE_2500BASEX)
> val |= MV_NETC_GE_MAC2_SGMII;
> @@ -3530,7 +3480,6 @@ static u32 mvpp2_netc_cfg_create(int gop_id, phy_interface_t phy_type)
>
> if (gop_id == 3) {
> if (phy_type == PHY_INTERFACE_MODE_SGMII ||
> - phy_type == PHY_INTERFACE_MODE_SGMII_2500 ||
> phy_type == PHY_INTERFACE_MODE_1000BASEX ||
> phy_type == PHY_INTERFACE_MODE_2500BASEX)
> val |= MV_NETC_GE_MAC3_SGMII;
> @@ -4529,7 +4478,6 @@ static void mvpp2_start_dev(struct mvpp2_port *port)
> case PHY_INTERFACE_MODE_RGMII:
> case PHY_INTERFACE_MODE_RGMII_ID:
> case PHY_INTERFACE_MODE_SGMII:
> - case PHY_INTERFACE_MODE_SGMII_2500:
> case PHY_INTERFACE_MODE_1000BASEX:
> case PHY_INTERFACE_MODE_2500BASEX:
> mvpp2_gmac_max_rx_size_set(port);
> @@ -5263,7 +5211,6 @@ static int mvpp2_start(struct udevice *dev)
> case PHY_INTERFACE_MODE_RGMII:
> case PHY_INTERFACE_MODE_RGMII_ID:
> case PHY_INTERFACE_MODE_SGMII:
> - case PHY_INTERFACE_MODE_SGMII_2500:
> case PHY_INTERFACE_MODE_1000BASEX:
> case PHY_INTERFACE_MODE_2500BASEX:
> mvpp2_port_power_up(port);
> --
> 2.39.2
>
Reviewed-by: Ramon Fried <rfried.dev at gmail.com>
More information about the U-Boot
mailing list