[PATCH] net: ravb: Support fixed PHY in R-Car

Ramon Fried rfried.dev at gmail.com
Sun Apr 2 09:39:02 CEST 2023


On Tue, Feb 28, 2023 at 1:04 AM Marek Vasut
<marek.vasut+renesas at mailbox.org> wrote:
>
> From: Mikhail Lappo <mikhail.lappo at esrlabs.com>
>
> Calling old U-Boot API doesn't allow to use fixed PHY.
> Searching by mask is the part of new function, after
> scanning FDT for a fixed PHY definition
>
> Fixes: e821a7bdb13 ("net: ravb: Detect PHY correctly")
> Reviewed-by: Marek Vasut <marek.vasut+renesas at mailbox.org>
> Signed-off-by: Mikhail Lappo <mikhail.lappo at esrlabs.com>
> Signed-off-by: Hai Pham <hai.pham.ud at renesas.com>
> [Hai Pham: Drop phy_connect_dev since it's called in phy_connect]
> Signed-off-by: Marek Vasut <marek.vasut+renesas at mailbox.org>
> [Marek: Use mask -1 instead of 0 to reinstate the search behavior
>         over all PHY addresses. Add Fixes tag, sort the tag list.]
> ---
> Cc: Joe Hershberger <joe.hershberger at ni.com>
> Cc: Ramon Fried <rfried.dev at gmail.com>
> ---
>  drivers/net/ravb.c | 6 ++----
>  1 file changed, 2 insertions(+), 4 deletions(-)
>
> diff --git a/drivers/net/ravb.c b/drivers/net/ravb.c
> index 5a835cc06ff..0bc50dc7335 100644
> --- a/drivers/net/ravb.c
> +++ b/drivers/net/ravb.c
> @@ -310,7 +310,7 @@ static int ravb_phy_config(struct udevice *dev)
>         struct ravb_priv *eth = dev_get_priv(dev);
>         struct eth_pdata *pdata = dev_get_plat(dev);
>         struct phy_device *phydev;
> -       int mask = 0xffffffff, reg;
> +       int reg;
>
>         if (dm_gpio_is_valid(&eth->reset_gpio)) {
>                 dm_gpio_set_value(&eth->reset_gpio, 1);
> @@ -319,12 +319,10 @@ static int ravb_phy_config(struct udevice *dev)
>                 mdelay(1);
>         }
>
> -       phydev = phy_find_by_mask(eth->bus, mask);
> +       phydev = phy_connect(eth->bus, -1, dev, pdata->phy_interface);
>         if (!phydev)
>                 return -ENODEV;
>
> -       phy_connect_dev(phydev, dev, pdata->phy_interface);
> -
>         eth->phydev = phydev;
>
>         phydev->supported &= SUPPORTED_100baseT_Full |
> --
> 2.39.2
>
Reviewed-by: Ramon Fried <rfried.dev at gmail.com>


More information about the U-Boot mailing list