[PATCH v1 1/2] configs: starfive: Enable PCIE auto enum and NVME/USB stuff for Starfive Visionfive 2

[Shengyu Qu]

Although PCIE driver already exists, board defconfig isn't configured to
enable PCIE enum on boot, thus USB storage device and NVME drive are not
supported by default. So modify defconfig to enable PCIE auto enum, then
start USB subsystem and scan nvme drive on boot.

Signed-off-by: Shengyu Qu <wiagn233 at outlook.com>
---
 configs/starfive_visionfive2_defconfig | 8 +++++++-
 1 file changed, 7 insertions(+), 1 deletion(-)

diff --git a/configs/starfive_visionfive2_defconfig b/configs/starfive_visionfive2_defconfig
index e9b63e5b84..3002c96f0e 100644
--- a/configs/starfive_visionfive2_defconfig
+++ b/configs/starfive_visionfive2_defconfig
@@ -30,6 +30,7 @@ CONFIG_SPL_SPI=y
 CONFIG_SYS_LOAD_ADDR=0x82000000
 CONFIG_SYS_PCI_64BIT=y
 CONFIG_PCI=y
+CONFIG_PCI_INIT_R=y
 CONFIG_TARGET_STARFIVE_VISIONFIVE2=y
 CONFIG_SPL_OPENSBI_LOAD_ADDR=0x40000000
 CONFIG_ARCH_RV64I=y
@@ -43,7 +44,7 @@ CONFIG_SD_BOOT=y
 CONFIG_USE_BOOTARGS=y
 CONFIG_BOOTARGS="console=ttyS0,115200 debug rootwait earlycon=sbi"
 CONFIG_USE_PREBOOT=y
-CONFIG_PREBOOT="setenv fdt_addr ${fdtcontroladdr};fdt addr ${fdtcontroladdr};"
+CONFIG_PREBOOT="nvme scan; usb start; setenv fdt_addr ${fdtcontroladdr}; fdt addr ${fdtcontroladdr};"
 CONFIG_DEFAULT_FDT_FILE="starfive/jh7110-starfive-visionfive-2.dtb"
 CONFIG_DISPLAY_CPUINFO=y
 CONFIG_DISPLAY_BOARDINFO=y
@@ -124,4 +125,9 @@ CONFIG_TIMER_EARLY=y
 CONFIG_USB=y
 CONFIG_USB_XHCI_HCD=y
 CONFIG_USB_XHCI_PCI=y
+CONFIG_USB_EHCI_HCD=y
+CONFIG_USB_EHCI_PCI=y
+CONFIG_USB_OHCI_HCD=y
+CONFIG_USB_OHCI_PCI=y
+CONFIG_USB_STORAGE=y
 CONFIG_USB_KEYBOARD=y
-- 
2.42.0