[PATCH v2 2/3] sunxi: H616: remove default AXP305 selection

[Andre Przywara]

The original H616 devices released about three years ago were typically
paired with an X-Powers AXP305 PMIC. Newer devices uses the smaller
AXP313, and there seem to be far more systems with this PMIC around now.

Remove the default AXP305 selection for the H616 SoC from the Kconfig,
and move the PMIC selection into the board defconfig files instead.

Signed-off-by: Andre Przywara <andre.przywara at arm.com>
Reviewed-by: Jaehoon Chung <jh80.chung at samsung.com>
---
 configs/orangepi_zero2_defconfig | 1 +
 configs/x96_mate_defconfig       | 1 +
 drivers/power/Kconfig            | 1 -
 3 files changed, 2 insertions(+), 1 deletion(-)

diff --git a/configs/orangepi_zero2_defconfig b/configs/orangepi_zero2_defconfig
index 50009e823cb..98aed846f1f 100644
--- a/configs/orangepi_zero2_defconfig
+++ b/configs/orangepi_zero2_defconfig
@@ -20,6 +20,7 @@ CONFIG_SYS_I2C_SPEED=400000
 CONFIG_SPI_FLASH_MACRONIX=y
 CONFIG_PHY_REALTEK=y
 CONFIG_SUN8I_EMAC=y
+CONFIG_AXP305_POWER=y
 CONFIG_SPI=y
 CONFIG_USB_EHCI_HCD=y
 CONFIG_USB_OHCI_HCD=y
diff --git a/configs/x96_mate_defconfig b/configs/x96_mate_defconfig
index 318951e19c2..e805e0952b3 100644
--- a/configs/x96_mate_defconfig
+++ b/configs/x96_mate_defconfig
@@ -18,6 +18,7 @@ CONFIG_SPL_SYS_I2C_LEGACY=y
 CONFIG_SYS_I2C_MVTWSI=y
 CONFIG_SYS_I2C_SLAVE=0x7f
 CONFIG_SYS_I2C_SPEED=400000
+CONFIG_AXP305_POWER=y
 CONFIG_SUPPORT_EMMC_BOOT=y
 CONFIG_USB_EHCI_HCD=y
 CONFIG_USB_OHCI_HCD=y
diff --git a/drivers/power/Kconfig b/drivers/power/Kconfig
index 2395720c99c..33b8bc1214d 100644
--- a/drivers/power/Kconfig
+++ b/drivers/power/Kconfig
@@ -56,7 +56,6 @@ choice
 	depends on ARCH_SUNXI
 	default AXP209_POWER if MACH_SUN4I || MACH_SUN5I || MACH_SUN7I
 	default AXP221_POWER if MACH_SUN6I || MACH_SUN8I_A23 || MACH_SUN8I_A33 || MACH_SUN8I_R40
-	default AXP305_POWER if MACH_SUN50I_H616
 	default AXP818_POWER if MACH_SUN8I_A83T
 	default SUNXI_NO_PMIC if MACH_SUNXI_H3_H5 || MACH_SUN50I || MACH_SUN8I_V3S
 
-- 
2.35.8