[PATCH v2 17/30] spi: cadence_qspi: Fix versal ospi indirect write timed out issue
Tejas Bhumkar
tejas.arvind.bhumkar at amd.com
Wed Dec 6 10:31:28 CET 2023
To reduce the CPU load in waiting for the OSPI internal SRAM to
clear in indirect mode, it's better to use the
CQSPI_REG_IRQSTATUS register to check for indirect operation to complete.
Enabled interrupt for Indirect Complete and Transfer Watermark
Breach interrupt status register bits and using readl_poll_timeout
function to poll for Indirect Operation Complete bit gets set.
Here not enabling IRQ coming to GIC, only IRQ from IP itself is able
to poll bits.
It is observed that the Indirect Operation Complete bit is getting
set at an average time of 0.172 usec.
Signed-off-by: Tejas Bhumkar <tejas.arvind.bhumkar at amd.com>
---
drivers/spi/cadence_qspi.h | 11 +++++++++++
drivers/spi/cadence_qspi_apb.c | 24 +++++++++++++++++++-----
2 files changed, 30 insertions(+), 5 deletions(-)
diff --git a/drivers/spi/cadence_qspi.h b/drivers/spi/cadence_qspi.h
index 505f59bed9..73ef44fc1c 100644
--- a/drivers/spi/cadence_qspi.h
+++ b/drivers/spi/cadence_qspi.h
@@ -252,6 +252,17 @@
(((readl((reg_base) + CQSPI_REG_SDRAMLEVEL)) >> \
CQSPI_REG_SDRAMLEVEL_WR_LSB) & CQSPI_REG_SDRAMLEVEL_WR_MASK)
+/* Interrupt status bits */
+#define CQSPI_REG_IRQ_UNDERFLOW BIT(1)
+#define CQSPI_REG_IRQ_IND_COMP BIT(2)
+#define CQSPI_REG_IRQ_WATERMARK BIT(6)
+
+#define CQSPI_IRQ_MASK_WR (CQSPI_REG_IRQ_IND_COMP | \
+ CQSPI_REG_IRQ_WATERMARK | \
+ CQSPI_REG_IRQ_UNDERFLOW)
+
+#define CQSPI_IRQ_STATUS_MASK GENMASK(16, 0)
+
struct cadence_spi_plat {
unsigned int max_hz;
void *regbase;
diff --git a/drivers/spi/cadence_qspi_apb.c b/drivers/spi/cadence_qspi_apb.c
index d1a5a4c679..1b649abf21 100644
--- a/drivers/spi/cadence_qspi_apb.c
+++ b/drivers/spi/cadence_qspi_apb.c
@@ -32,6 +32,7 @@
#include <linux/bitops.h>
#include <linux/delay.h>
#include <linux/errno.h>
+#include <linux/iopoll.h>
#include <wait_bit.h>
#include <spi.h>
#include <spi-mem.h>
@@ -855,7 +856,7 @@ cadence_qspi_apb_indirect_write_execute(struct cadence_spi_priv *priv,
const u8 *bb_txbuf = txbuf;
void *bounce_buf = NULL;
unsigned int write_bytes;
- int ret;
+ int ret, cr;
if (priv->edge_mode == CQSPI_EDGE_MODE_DDR && (n_tx % 2) != 0)
n_tx++;
@@ -873,9 +874,15 @@ cadence_qspi_apb_indirect_write_execute(struct cadence_spi_priv *priv,
bb_txbuf = bounce_buf;
}
- /* Configure the indirect read transfer bytes */
+ /* Configure the indirect write transfer bytes */
writel(n_tx, priv->regbase + CQSPI_REG_INDIRECTWRBYTES);
+ /* Clear all interrupts */
+ writel(CQSPI_IRQ_STATUS_MASK, priv->regbase + CQSPI_REG_IRQSTATUS);
+
+ /* Enable interrupt for corresponding interrupt status register bit's */
+ writel(CQSPI_IRQ_MASK_WR, priv->regbase + CQSPI_REG_IRQMASK);
+
/* Start the indirect write transfer */
writel(CQSPI_REG_INDIRECTWR_START,
priv->regbase + CQSPI_REG_INDIRECTWR);
@@ -894,9 +901,10 @@ cadence_qspi_apb_indirect_write_execute(struct cadence_spi_priv *priv,
bb_txbuf + rounddown(write_bytes, 4),
write_bytes % 4);
- ret = wait_for_bit_le32(priv->regbase + CQSPI_REG_SDRAMLEVEL,
- CQSPI_REG_SDRAMLEVEL_WR_MASK <<
- CQSPI_REG_SDRAMLEVEL_WR_LSB, 0, 10, 0);
+ /* Wait up to Indirect Operation Complete bit to set */
+ ret = readl_poll_timeout(priv->regbase + CQSPI_REG_IRQSTATUS, cr,
+ cr & CQSPI_REG_IRQ_IND_COMP, 10);
+
if (ret) {
printf("Indirect write timed out (%i)\n", ret);
goto failwr;
@@ -914,6 +922,9 @@ cadence_qspi_apb_indirect_write_execute(struct cadence_spi_priv *priv,
goto failwr;
}
+ /* Disable interrupt. */
+ writel(0, priv->regbase + CQSPI_REG_IRQMASK);
+
/* Clear indirect completion status */
writel(CQSPI_REG_INDIRECTWR_DONE,
priv->regbase + CQSPI_REG_INDIRECTWR);
@@ -931,6 +942,9 @@ cadence_qspi_apb_indirect_write_execute(struct cadence_spi_priv *priv,
return 0;
failwr:
+ /* Disable interrupt. */
+ writel(0, priv->regbase + CQSPI_REG_IRQMASK);
+
/* Cancel the indirect write */
writel(CQSPI_REG_INDIRECTWR_CANCEL,
priv->regbase + CQSPI_REG_INDIRECTWR);
--
2.27.0
More information about the U-Boot
mailing list